Removing the Display Assembly
(HP Authorized Service Providers Only)
Required Equipment
∙Small Phillips screwdriver.
∙Plastic knife or small
Removal Procedure
1.Unplug the AC adapter, if present, and remove the battery.
2.Open the display completely (180 degrees).
3.Use a plastic knife or small
4.Remove the cover by pulling it to your right.
5.Use a Phillips screwdriver to remove the four screws from the hinge covers.
6.Remove the hinge covers with your fingers. Do not use a tool.
7.Unplug the cable by grasping both ends of the connector and pulling toward you.
8.Use a Phillips screwdriver to remove the four screws from the hinges.
“Step 5” screws (4): 
M2.5×4mm
“Step 8” screws (4): 
M2.5×5mm
Figure 2-7. Removing the Display Assembly
Reassembly Notes
∙You may need to use a
HP OmniBook XE2 | Removal and Replacement |