Correct Usage, „ Preparation, Start, Stop

4-way Air Discharge Cassette Type

Owner’s Manual

6. CORRECT USAGE

•When you use the air conditioner for the first time or when you change the setting, follow the steps below.

Settings are saved in memory and are displayed anytime the unit is turned on by pushing the button.

Preparation

• When the circuit breaker is turned on, the partition lines are displayed on the remote control.

*After the circuit breaker is turned on, the remote control does not accept any commands for approx. 1 minute, this is not a failure.

REQUIREMENT

•When you re-power the air conditioner after it has not been used for a long period, turn on the circuit breaker at least 12 hours before starting the air conditioner.

TEMP.			ON / OFF		1
4				3	1
4					2
	TIMER SET	FAN	MODE
	TIME	SAVE	VENT
FILTER	SET CL	SWING/FIX	UNIT LOUVER
RESET TEST	SET CL	SWING/FIX	UNIT LOUVER

Start

1 Push button.

The operation lamp illuminates, and the operation starts.

2 Select an operation mode with the “ ” button.

One push of the button, and the display changes in the order shown below.

AUTO HEAT DRY COOL FAN

3 Select fan speed with “

” button.

One push of the button, and the display changes in the order shown below.

AUTO HIGH MED.. LOW

•When fan is in “ AUTO”, fan speed is adjusted based on difference between set point and room temperature.

•In heating operation, if the room temperature is not heated sufficiently with volume “ LOW”

operation, select “ MED.” or “ HIGH” operation.

•The temperature sensor detects the return air temperature at the indoor unit, which differs from the room temperature depending on the installation condition.

Set point is a target of room temperature.

( “AUTO” is not selectable in the FAN mode.)

4 Select the set point temperature by pushing the “TEMP. ” or “TEMP. ” buttons.

Stop

Push button.

The operation lamp goes off, and the operation stops. In the COOL, DRY, or AUTO (cooling) mode, the fan runs for 10 minutes (or more) for self cleaning.

– 10 –

10-EN