Toshiba RAV-SP420UT-UL, RAV-SP300UT-UL Auto Changeover, When restarting the operation after stop

Page 12

4-way Air Discharge Cassette Type

Owner’s Manual

NOTE

Auto Changeover

•When in Auto Mode, the unit selects the operating mode (cooling, heating or fan only) based on the user selected set point temperature.

•If the Auto mode is uncomfortable, you can select the desired conditions manually.

Cooling

•If there is a demand for cooling, unit will start approximately 1 minute after mode is selected.

Heating

•If there is a demand for heating, unit will start approximately 3 to 5 minutes after the mode is selected.

•After the heating operation has stopped, FAN may continue to run for approx. 30 seconds.

•When the room temperature reaches the set temperature and the outdoor unit stops, the indoor unit fan runs at ultra low speed and the outdoor unit fan runs at low speed.

During defrost operation, the fan stops so that cool air is not discharged. (“ ” Pre-heat is displayed.)

When restarting the operation after stop

•When attempting to restart the unit immediately after it was stopped, the unit can not start for approx. 3 minutes this is to protect the compressor.

11-EN

– 11 –

Image 12

Contents AIR Conditioner Split Type Contents Precautions for Safety Way Air Discharge Cassette Type System Characteristics Select a comfortable set point and minimize adjusting it Energy Saving RecommendationsChecks before operating Part Names „ Indoor unit„ Outdoor unit Part sold separatelyWired Remote Control „ Display sectionSelf cleaning display Power saving mode displayPre-heat display No function displayRemote control sensor „ Operation sectionButton Operation lampCorrect Usage „ PreparationStart StopWhen restarting the operation after stop Auto ChangeoverTimer Operation „ Timer operationCancel of timer operation SetLouver Direction For cooling For heatingDisplay when stopping the swing Set louver directionHeat operation COOL/DRY operationSelect a louver you want to adjust by „ Set louver direction individuallyOperation Pushing right side of the buttonPower Saving Mode Self Cleaning ModeTo stop self cleaning, push button twice in succession Push button during operationAdvanced Settings „ Swing modePush button to complete the setting „ Louver lock No swingPush button to lock the louver „ Cancel louver lock „ Change power saving mode settingPush Time buttons to adjust the power-save setting Push left side of button to select an indoor unit to be setMaintenance Periodic MaintenanceBe sure to clean the heat exchanger with pressurized water Replacing antibacterial glassCleaning the air filter Cleaning Unit Grille and FrameCleaning The Louvers Preparing for long Shut Down PeriodInformation for Installation Installation placeElectrical wiring Do not install the air conditioner in the following placesMaintenance Re-InstallationBe careful with noise or vibrations Trouble Shooting Fan does not stop when the operation is stoppedIndoor unit or outdoor unit makes a strange noise RecheckWhen the protective device is activated Protective deviceDo not turn off the circuit breaker Memo EH99933501