Toshiba RAV-SP360UT-UL Set louver direction, Heat operation, COOL/DRY operation, FAN operation

Page 15

4-way Air Discharge Cassette Type

Owner’s Manual

Set louver direction

1 Push during operation.

The louver direction changes with every push of the button.

In HEAT operation

Direct the louver downward.

Initial setup

In COOL/DRY operation

Direct the louver horizontally.

Initial setup

In FAN operation

Select a desired louver direction.

Initial setup

Start swing operation

1 Push , set the louver direction to the

lowest position, and then push again.

SWING is displayed and the louvers swing automatically.

Display during swinging

Repeat

Unit select button

1

Stop swing operation

1 Push at a desired position while the louver is swinging.

When is pushed after that, the louver direction can be set again from the highest position.

In COOL/DRY mode, the louver does not stop as it directs downward. If stopping the louver as it directs downward during swing operation, it stops after moving to the third position from the highest position.

Display when stopping the swing

FAN/HEAT COOL/DRY

operation operation

Unit select

When multiple indoor units are controlled with one remote control, louver position can be set for all indoor units or each indoor unit individually.

To set louver direction for a particular unit, push

button to display an indoor unit number in the control group. Then set the louver direction of the displayed indoor unit by following the steps outlined above.

When no indoor unit number is displayed, all indoor units in the control group can be controlled simultaneously.

Each time you push (left side of the button), the display changes as follows:

 

UNIT No.

 

 

UNIT No.

 

 

UNIT No.

 

 

1-1

Not

1-2

UNIT No.

1-3

 

 

 

 

 

 

 

 

 

 

display

 

 

1-4

 

 

 

 

 

 

 

 

 

 

 

 

EN

– 14 –

14-EN

Image 15
Contents AIR Conditioner Split Type Contents Precautions for Safety Way Air Discharge Cassette Type System Characteristics Select a comfortable set point and minimize adjusting it Energy Saving RecommendationsChecks before operating Part sold separately Part Names„ Indoor unit „ Outdoor unit„ Display section Wired Remote ControlNo function display Self cleaning displayPower saving mode display Pre-heat displayOperation lamp Remote control sensor„ Operation section ButtonStop Correct Usage„ Preparation StartAuto Changeover When restarting the operation after stopSet Timer Operation„ Timer operation Cancel of timer operationFor cooling For heating Louver DirectionCOOL/DRY operation Display when stopping the swingSet louver direction Heat operationPushing right side of the button Select a louver you want to adjust by„ Set louver direction individually OperationPush button during operation Power Saving ModeSelf Cleaning Mode To stop self cleaning, push button twice in succession„ Swing mode Advanced SettingsPush button to complete the setting „ Louver lock No swingPush button to lock the louver Push left side of button to select an indoor unit to be set „ Cancel louver lock„ Change power saving mode setting Push Time buttons to adjust the power-save settingReplacing antibacterial glass MaintenancePeriodic Maintenance Be sure to clean the heat exchanger with pressurized waterPreparing for long Shut Down Period Cleaning the air filterCleaning Unit Grille and Frame Cleaning The LouversDo not install the air conditioner in the following places Information for InstallationInstallation place Electrical wiringMaintenance Re-InstallationBe careful with noise or vibrations Recheck Trouble ShootingFan does not stop when the operation is stopped Indoor unit or outdoor unit makes a strange noiseWhen the protective device is activated Protective deviceDo not turn off the circuit breaker Memo EH99933501