Toshiba RAV-SP300UT-UL, RAV-SP420UT-UL Pre-heat display, No function display, Fan speed display

Page 9

4-way Air Discharge Cassette Type

Owner’s Manual

		1	7 8 9
		2
		3
	4	20
	6	5
	6	21	14
	15	21	14
	15	18
		18

161917

10

11

12

13

12 Pre-heat display

19 UNIT No. display

Displayed when the heating mode is energized or defrost cycle is initiated.

While this indication is displayed, the indoor fan stops.

13 No function display

Displayed when the function requested is not available on that model.

14 Fan speed display

The selected fan speed mode is displayed. (AUTO)

(HIGH) (MED.)

(LOW)

15 Louver Number display.

Louvers can be controlled individually. Displays which louver is being set.

(exapmle:01, 02, 03, 04)

16 Self cleaning display

Displays the number of the indoor unit selected. Also displays error code of indoor and outdoor units

20 SET DATA

Displayed during advanced setting.

21 Service display

Displayed during self cleaning operation to dry the indoor heat exchanger.

17 Power saving mode display

Limits compressor speed (capacity) to save energy.

18 Louver lock display

Displayed when louver is locked or there is a louver-locked unit in the group.

EN

– 8 –

8-EN

Image 9

Contents AIR Conditioner Split Type Contents Precautions for Safety Way Air Discharge Cassette Type System Characteristics Select a comfortable set point and minimize adjusting it Energy Saving RecommendationsChecks before operating „ Indoor unit Part Names„ Outdoor unit Part sold separately„ Display section Wired Remote ControlPower saving mode display Self cleaning displayPre-heat display No function display„ Operation section Remote control sensorButton Operation lamp„ Preparation Correct UsageStart StopAuto Changeover When restarting the operation after stop„ Timer operation Timer OperationCancel of timer operation SetFor cooling For heating Louver DirectionSet louver direction Display when stopping the swingHeat operation COOL/DRY operation„ Set louver direction individually Select a louver you want to adjust byOperation Pushing right side of the buttonSelf Cleaning Mode Power Saving ModeTo stop self cleaning, push button twice in succession Push button during operation„ Swing mode Advanced SettingsPush button to complete the setting „ Louver lock No swingPush button to lock the louver „ Change power saving mode setting „ Cancel louver lockPush Time buttons to adjust the power-save setting Push left side of button to select an indoor unit to be setPeriodic Maintenance MaintenanceBe sure to clean the heat exchanger with pressurized water Replacing antibacterial glassCleaning Unit Grille and Frame Cleaning the air filterCleaning The Louvers Preparing for long Shut Down PeriodInstallation place Information for InstallationElectrical wiring Do not install the air conditioner in the following placesMaintenance Re-InstallationBe careful with noise or vibrations Fan does not stop when the operation is stopped Trouble ShootingIndoor unit or outdoor unit makes a strange noise RecheckWhen the protective device is activated Protective deviceDo not turn off the circuit breaker Memo EH99933501