Toshiba RAV-SP420UT-UL, RAV-SP300UT-UL „ Cancel louver lock, „ Change power saving mode setting

Page 20

4-way Air Discharge Cassette Type

Owner’s Manual

„Cancel louver lock

Set the louver direction to “0000” in step 4 of the louver lock setup procedure.

SET DATA

“0000”

When the setting is cancelled, goes out.

Perform the same operations as steps 1, 2, 3, 5, and 6 above.

„Change power saving mode setting

5 4

1 Push button for at least four seconds when the air conditioner is not working.

and numbers flash.

2 Push (left side of button) to select an indoor unit to be set.

Each time you push the button, unit numbers change as follows:

UNIT No.

 

UNIT No.

 

UNIT No.

1-1

 

1-2

 

1-3

UNIT No. 1-4

The fan of the selected unit runs and the louvers start swinging.

1

3

2

3 Push TIME buttons to adjust the power-save setting.

Each push of the button changes the power level by 1% within the range from 100% to 50%.

* The factory default is 75%.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Setting of power level in

 

 

 

 

 

 

 

 

4

 

 

 

 

 

 

 

power saving mode

Push

button.

5

Push

button to complete the setting.

19-EN

– 19 –

Image 20
Contents AIR Conditioner Split Type Contents Precautions for Safety Way Air Discharge Cassette Type System Characteristics Checks before operating Select a comfortable set point and minimize adjusting itEnergy Saving Recommendations Part Names „ Indoor unit„ Outdoor unit Part sold separatelyWired Remote Control „ Display sectionSelf cleaning display Power saving mode displayPre-heat display No function displayRemote control sensor „ Operation sectionButton Operation lampCorrect Usage „ PreparationStart StopWhen restarting the operation after stop Auto ChangeoverTimer Operation „ Timer operationCancel of timer operation SetLouver Direction For cooling For heatingDisplay when stopping the swing Set louver directionHeat operation COOL/DRY operationSelect a louver you want to adjust by „ Set louver direction individuallyOperation Pushing right side of the buttonPower Saving Mode Self Cleaning ModeTo stop self cleaning, push button twice in succession Push button during operationAdvanced Settings „ Swing modePush button to lock the louver Push button to complete the setting„ Louver lock No swing „ Cancel louver lock „ Change power saving mode settingPush Time buttons to adjust the power-save setting Push left side of button to select an indoor unit to be setMaintenance Periodic MaintenanceBe sure to clean the heat exchanger with pressurized water Replacing antibacterial glassCleaning the air filter Cleaning Unit Grille and FrameCleaning The Louvers Preparing for long Shut Down PeriodInformation for Installation Installation placeElectrical wiring Do not install the air conditioner in the following placesBe careful with noise or vibrations MaintenanceRe-Installation Trouble Shooting Fan does not stop when the operation is stoppedIndoor unit or outdoor unit makes a strange noise RecheckDo not turn off the circuit breaker When the protective device is activatedProtective device Memo EH99933501