| Owner’s Manual |
5. WIRED REMOTE CONTROL
This remote control can control the operation of up to 8 indoor units.
The remote control has two sections: The display section and the operation section.
Display section
In the display below all the icons are shown. When the unit is in operation, only relevant icons will be displayed.
•When the circuit breaker is turned on the first time, 
flashes on the display part of the remote control.
•While this display is flashing, the model is being automatically confirmed.
Wait till 
display has disappeared to use the remote control.
Pertition line
|
|
| Display |
|
|
| section |
TEMP. |
| ON / OFF |
|
TIMER SET | FAN | MODE | Operation |
TIME | SAVE | VENT | section |
FILTER | SWING/FIX | UNIT LOUVER |
|
RESET TEST SET CL |
|
| 1 | 7 8 9 | |
| 2 |
| |
| 3 |
| |
4 | 20 |
| |
6 | 5 |
| |
21 | 14 | ||
15 | |||
|
|
18
161917
10
11
12
13
1
2
3
SETTING display
Displayed during setup of the timer etc..
Operation mode
The selected operation mode is displayed.
Error display
Displayed while the protective device works or a error occurs.
7
8
9
TEST run display
Displayed during a test run.
Louver position display
Displays louver position.
Swing display
Displayed during up/down movement of the louver.
4
5
6
Timer display
When a malfunction occurs, an error code is displayed.
Timer Mode display
Displays the timer mode.
Filter display
, reminder to clean the air filter.
10
11
Set temperature display
The selected set temp. is displayed.
Remote control sensor display
Displayed while the sensor of the remote control is used.
– 7 – |