HP Pro 110 manual Computer Setup-Boot

Table 3-3Computer Setup—Power

Option	Description
After AC Power	Allows you to select system restart behavior after power loss:
Failure	●	Stay Off (default)
	●	Power On
	●	Auto
XD(Execute Disable)	Disables/enables XD bit. Default is enabled.
Virtualization	Allows you to enable/disable the virtualization features of the processor. Changing this setting
Technology	requires turning the computer off and then back on. Default is disabled.
WOL in S5	Allows you to enable/disable limited (normal shutdown) WOL from S5 support. Default is disabled.

Computer Setup—Boot

NOTE: Support for specific Computer Setup options may vary depending on the hardware configuration.

Table 3-4Computer Setup—Boot

Option	Description
Boot-time Diagnostic	Disables/enables POST diagnostic messages display. Default is disabled.
Screen
ESC: Boot Menu	Enables/disables the ability to press the Esc key to access the boot menu during boot.
F9: Diagnostics	Enables/disables the ability to press the F9 key to access the Diagnostics menu during boot.
F10: Setup	Enables/disables the ability to press the F10 key to access the Setup menu during boot.
F11: Recovery	Enables/disables the ability to press the F11 key to access the recovery menu during boot.
F12: Boot from LAN	Enables/disables the ability to press the F12 key to boot from LAN.
Boot Device Priority	Allows you to specify which device groups will boot first, second, third, and fourth or to disable any
1st Boot Device	of the four:
	●	Floppy Group
2nd Boot Device
	● CD-ROM Group
3rd Boot Device
	●	Hard Drive Group
4th Boot Device
	●	Network Boot Group
	NOTE: MS-DOS drive lettering assignments may not apply after a non-MS-DOS operating
	system has started.
Floppy Group Boot	Specifies boot device priority within removable devices.
Priority	Press Enter to select the device, up or down arrow to move the selected device, Enter to select
	the device, Esc to abort.
CD-ROM Group Boot	Specifies boot device priority within CD/DVD drives.
Priority

10 Chapter 3 Computer Setup (F10) Utility