HP 800 G1 21.5 Non-Touch manual Solving CD-ROM and DVD problems, Security Network Boot

Solving CD-ROM and DVD problems

If you encounter CD-ROM or DVD problems, see the common causes and solutions listed in the following table or to the documentation that came with the optional device.

System will not boot from CD-ROM or DVD drive.

Cause	Solution
The device is attached to a SATA port that has been hidden in	Run the Computer Setup utility and ensure Device Available
the Computer Setup utility.	is selected for the device's SATA port in Security > Device
	Security.
Removable Media Boot is disabled in the Computer Setup	Run the Computer Setup utility and enable booting to
utility.	removable media in Storage > Storage Options. Ensure
	CD-ROM is enabled in Storage > Boot Order.
Network Boot is enabled in Computer Setup.	Run the Computer Setup utility and disable Network Boot in
	Security > Network Boot.
Non-bootable CD in drive.	Try a bootable CD in the drive.
Boot order not correct.	Run the Computer Setup utility and change boot sequence in
	Storage > Boot Order.
Drive not found (identified).
Cause	Solution
Cable could be loose.	Check cable connections.
The system may not have automatically recognized a newly	See reconfiguration directions in the Solving Hardware
installed device.	Installation Problems on page 150 section. If the system still
	does not recognize the new device, check to see if the device
	is listed within Computer Setup. If it is listed, the probable
	cause is a driver problem. If it is not listed, the probable cause
	is a hardware problem.
	If this is a newly installed drive, run the Computer Setup utility
	and try adding a POST delay under Advanced > Power-
	On Options.
The device is attached to a SATA port that has been hidden in	Run the Computer Setup utility and ensure Device Available
Computer Setup.	is selected for the device's SATA port in Security > Device
	Security.
Drive responds slowly immediately after power-up.	Run Computer Setup and increase the POST Delay in
	Advanced > Power-On Options.

CD-ROM or DVD devices are not detected or driver is not loaded.

Cause	Solution
Drive is not connected properly or not properly configured.	See the documentation that came with the optional device.

Solving CD-ROM and DVD problems 159