HP serviceguard t2808-90006 manual Execute the commands that With md0 consisting of only

			Disaster Scenarios and Their Handling
Table 4-1	Disaster Scenarios and Their Handling (Continued)
Disaster Scenario		What Happens When	Recovery Process
		This Disaster Occurs
This scenario is an extension of		If the FC links are not	Complete the following procedure
the previous failure scenario. In		restored on N2, you can only	to initiate a recovery:
the previous scenario, when the		start the package forcefully.	1. Reconnect the FC links
package fails over to N2, it does		You can forcefully start a
not start as the value of		package only if it is	between the data centers. As a
RPO_TARGET would have been		determined that the	result, S1
exceeded.		associated data loss is	(/dev/hpdev/mylink-sde)
To forcefully start the package		acceptable.	becomes accessible from N2
			2. Run the following command to
P1 on N2 when the FC links are		After you execute the force
not restored on N2, check the		start commands, package	add S1 to md0 on N2
package log file on N2 and		P1 starts on N2 and runs	# mdadm --add /dev/md0
execute the commands that		with md0 consisting of only
			/dev/hpdev/mylink-sde
appear in it.		S2
		(/dev/hpdev/mylink-sdf).	This command initiates the
			re-mirroring process from S2 to
			S1. When re-mirroring is complete,
			the extended distance cluster
			detects S1 and accepts it as part of
			md0.

Chapter 4 93