Section 8: Programming Descriptions
Keypad Programming
To access Keypad Programming enter [ ][8][Installer’s Code][ ].
To return to System Programming press [ ].
System Labels
There are 39 programmable system labels which are programmable through the Keypad or Downloading. Once a label programming section has been entered, use the [<] and [>] Cursor keys to move left and right to get to another letter within the label. The letters of the alphabet are divided up among the number keys
[<] = Display Left (Previous) | [6] | = P Q R 6 | |
[>] = Display Right (Next) | [7] | = S T U 7 | |
[1] | = A B C 1 | [8] | = V W X 8 |
[2] | = D E F 2 | [9] | = Y Z 9 0 |
[3] | = G H I 3 | [0] | = SPACE |
[4] | = J K L 4 | [*] = SELECT | |
[5] | = M N O 5 | [#] = ESCAPE | |
For example, if you press the [4] key once, the letter “J” will appear above the cursor on the display. Press the [4] key again, the next letter “K” will appear, and so on. If a different number is pressed, e.g. the [6] key, the cursor will automatically move to the right one space, i.e. the letter “P”. To erase a character, use the [<] [>] keys to move the cursor under the character, then press the [0] key. If the [0] key is pressed, and [<] or [>] was the previous key pressed, the character over the cursor will be cleared. If any other key was previously pressed, then increment to and clear the next character. While programming a label, press the [ ] key to call up an options menu. To select an option, scroll through the options using the [<] [>] keys, then press the [ ] key to select.
SAVE | Saves the new label. |
CHANGE CASE | Toggles the letter entry between upper case letters (A,B,C...) and lower case letters (a,b,c...). |
ASCII ENTRY | For entering uncommon characters. There are 255 characters. |
| Use the [<] [>] keys to scroll through the characters or enter a 3 digit number from |
| Press the [*] key to enter the character into the label. |
CLEAR TO END | Clears the display from the character where the cursor was located to the end of the display. |
CLEAR DISPLAY | Clears the entire label field. |
Section [001]-[034] Zone Labels
Enter a 28 character zone label for up to 32 wireless zones and 2 hardwired zones (33 & 34).
Default Value =
Section [065] Fire Alarm Labels
Enter a 28 character Fire Alarm label. Default Value =
Section [066] Fail to Arm Event Message
Enter a 32 character Fail to Arm Event Message. Default Value = ’SYSTEM HAS
Section [067] Alarm when Armed Event Message
Enter a 32 character Alarm when Armed Event Message. Default Value =
Section [068]-[069] Command Output Label
Enter a 28 character Command Output Label label for each command Output (2 MAX).
Default Value =
