SAFETY INSTRUCTIONS for SERVICE PERSONNEL
WARNING: When using equipment connected to the TELEPHONE NETWORK, there are basic safety instructions that should always be followed. Refer to the SAFETY INTRUCTIONS provided with this product; save them for (future) reference. Instruct the
Before Installing The Equipment
Do NOT use a sharp or metal object to open the packaging!
Ensure your package includes the following items:
•User’s Guide (Manual) including the SAFETY INSTRUCTIONS.
READ and SAVE These Instructions!
Follow All WARNINGS AND INSTRUCTIONS specified within these Instruction and/or on the equipment.
•Equipment SCW904x
•Power Supply, Direct
•Mounting Hardware.
Selecting A Suitable Location For The Alarm Controller
Use the following list as a guide to find a suitable place for this equipment:
•Locate it near a telephone socket and a power outlet.
•Select a place that is free from vibration and shocks.
•Place the Alarm Controller on a flat, stable surface and follow the Installation suggestions.
Do NOT locate this product where persons will walk on the secondary circuit cable(s). Do NOT use extension cords to
AVOID setting up the equipment near heaters, air conditioners, ventilators, and/or refrigerators Do NOT connect the Alarm Controller to electrical outlets on the same circuit as large appliances.
Do NOT select a place that exposes your alarm controller to direct sunlight, excessive heat, moisture, vapors, chemicals or dust.
Do NOT install this Equipment near water. (e.g., Bath Tub, Wash Bowl, Kitchen/Laundry sink, In a wet basement, or near swimming pool, etc.). Do NOT install this equipment and its accessories in areas where there is a risk of explosion.
Do NOT connect this Alarm Controller to electrical outlets controlled by wall switches or automatic timers; avoid interference sources.
SAFETY Precautions required during Installation:
•NEVER install this EQUIPMENT and/or TELEPHONE WIRING during A Lightning Storm!
•NEVER touch uninsulated Telephone wires or Terminals unless the telephone line has been disconnected at the network interface.
•Ensure that Cables are positioned so that accidents can not occur. Connected Cables must NOT be subject to excessive mechanical strain
•Use Only the Power Supply supplied with this equipment. Use of unauthorized power supplies may cause damage.
•The AC Socket/Outlet powering the equipment shall be located near the equipment and shall be easily accessible.
WARNING:
THIS EQUIPMENT HAS NO MAINS ON/OFF SWITCH. THE PLUG OF THE DIRECT
