HP 200 Unified Threat Management (UTM) Appliance Scheduling a job in the non-modular approach

•After job execution, the configuration interface, view, and user status that you have before job execution restores even if the job ran a command to change the user interface (for example, telnet, ftp, and ssh2), the view (for example, system-view and quit), or the user status (for example, super).

•The jobs run in the background without displaying any messages except log, trap and debugging messages.

•If you reboot the device, the system time and date are restored to the factory default. To make sure scheduled jobs can be executed at the expected time, you must change the system time and date or configure NTP for the device. For NTP configuration, see Network Management and Monitoring Configuration Guide.

•In the modular approach:

{Every job can have only one view and up to 10 commands. If you specify multiple views, the one specified last takes effect.

{Enter a view name in its complete form. Most commonly used view names include monitor for user view, system for system view, GigabitEthernet x/x for Ethernet interface view, and Vlan-interfacex for VLAN interface view.

{The time ID (time-id) must be unique in a job. If two time and command bindings have the same time ID, the one configured last takes effect.

Scheduling a job in the non-modular approach

To schedule a job, execute one of the following commands in user view:

Task Command Remarks

• Schedule a job to run a command at a specific

	time:
Schedule a job.	schedule job at time [ date ] view view
	command
	• Schedule a job to run a command after a delay:
	schedule job delay time view view command

Use either command.

If you execute the schedule job command multiple times, the most recent configuration takes effect.

Changing any clock setting can cancel the job set by using the schedule job command.

Scheduling a job in the modular approach

Step		Command	Remarks
1.	Enter system view.	system-view	N/A
2.	Create a job and enter	job job-name	N/A
	job view.
3.	Specify the view in which		You can specify only one view for
	the commands in the job	view view-name	a job. The job executes all
	run.		commands in the specified view.

100