HP 200 Unified Threat Management (UTM) Appliance manual Scheduled job configuration example

Step Command Remarks

4.Add commands to the job.

•Configure a command to run at a specific time and date:

time time-id at time date command command

•Configure a command to run at a specific time:

time time-id{ one-off repeating } at time [ month-date month-day week-day week-daylist] command command

•Configure a command to run after a delay:

time time-id{ one-off repeating } delay time command command

Use any of the commands.

Changing a clock setting does not affect the schedule set by using the time at or time delay command.

Scheduled job configuration example

Network requirements

Configure scheduled jobs on the firewall to enable interfaces GigabitEthernet 0/1, GigabitEthernet 0/2, and GigabitEthernet 0/3 at 8:00 and disabled them at 18:00 on working days every week, to control the access of the PCs connected to these interfaces.

Figure 73 Network diagram

Configuration procedure

# Enter system view.

<Firewall> system-view

# Create a job named pc1, and enter its view.

[Firewall] job pc1

# Configure the job to be executed in the view of GigabitEthernet 0/1.

[Firewall-job-pc1] view gigabitethernet 0/1

# Configure the firewall to enable GigabitEthernet 0/1 at 8:00 on working days every week.

[Firewall-job-pc1] time 1 repeating at 8:00 week-day mon tue wed thu fri command undo shutdown

#Configure the firewall to shut down GigabitEthernet 0/1 at 18:00 on working days every week.

101