HP 200 Unified Threat Management (UTM) Appliance Local login through the AUX port, Ssh2 server

Step		Command	Remarks
			By default, the system-predefined
14.	Specify SSH service for the		user admin can use terminal
		service-type ssh	service, Telnet service, SSH
	user.		service, and Web service, and no
			service type is specified for any
			other local user.
15.	Exit to system view.	quit	N/A
16.	Create an SSH user, and	ssh user username service-type
		stelnet authentication-type
	specify the authentication	{ password { any	N/A
	mode for the SSH user.	password-publickey publickey }
		assign publickey keyname }
17.	Configure common settings	See "Configuring common VTY	Optional.
	for VTY user interfaces.	user interface settings (optional)."

Using the device to log in to an SSH server

You can use the device as an SSH client to log in to an SSH server. If the server is located in a different subnet than the device, make sure the two devices have routes to reach each other.

Figure 36 Logging in to an SSH client from the device

Perform the following tasks in user view:

Task	Command	Remarks
Log in to an IPv4 SSH server.	ssh2 server	The server argument represents the IPv4 address or
		host name of the server.
		The server argument represents the IPv6 address or
		host name of the server.
Log in to an IPv6 SSH server.	ssh2 ipv6 server	NOTE:
		Support for the ssh2 ipv6 command depends on the
		device model. For more information, see Getting
		Started Command Reference.

To work with the SSH server, you might need to configure the SSH client. For information about configuring the SSH client, see Access Control Configuration Guide.

Local login through the AUX port

The following matrix shows the feature and hardware compatibility:

Hardware	Feature compatible
F1000-A-EI/F1000-S-EI	No
	38