HP 200 Unified Threat Management (UTM) Appliance manual Configuration items

Table 13 Configuration items

ItemDescription

Set the approach for obtaining the IP address, including:

•None—The IP address of the interface is not specified. The interface has no IP address.

	• Static Address—Specify the IP address for the interface
IP Configuration	manually. If you select this item, specify both the IP
	address and the mask.
	• DHCP—The interface obtains an IP address
	automatically through the DHCP protocol.
	• Do not change—The IP address of the interface does
	not change.

IMPORTANT:

Modification to the interface IP address results in disconnection with the device, so make changes with caution.

IP Address	If you select Stack Address as the approach for obtaining
	the IP address, set the interface IP address and network
Mask
	mask.

9.Click Next.

The page for configuring NAT appears.

Figure 60 Basic configuration wizard—5/6 (NAT configuration)

10.Configure the parameters as described in Table 14.

79