HP 200 Unified Threat Management (UTM) Appliance manual Logging in through Telnet, Telnet login

Step		Command	Remarks
			By default, the terminal display type
			is ANSI.
			The device supports two types of
			terminal display: ANSI and VT100.
			HP recommends setting the display
			type of both the device and the
9.	Specify the terminal display		terminal to VT100. If the device and
		terminal type { ansi vt100 }	the client use different display types
	type.
			(for example, HyperTerminal or
			Telnet terminal) or both are set to
			ANSI, when the total number of
			characters of the currently edited
			command line exceeds 80, an
			anomaly such as cursor corruption
			or abnormal display of the terminal
			display might occur on the client.
10. Configure the user privilege			By default, the default command
		user privilege level level	level is 3 for the console user
	level for login users.
			interface.
11. Set the maximum number of			By default, a screen displays 24
			lines at most.
	lines to be displayed on a	screen-length screen-length
			A value of 0 disables pausing
	screen.
			between screens of output.
12.	Set the size of command	history-command max-size value	By default, the buffer saves 10
	history buffer.		history commands at most.
			The default idle-timeout is 10
			minutes. The system automatically
			terminates the user's connection if
13.	Set the idle-timeout timer.	idle-timeout minutes [ seconds ]	there is no information interaction
			between the device and the user

within the idle-timeout time.

Setting idle-timeout to 0 disables the idle-timeout function.

Logging in through Telnet

NOTE:

Telnet login is not supported in FIPS mode.

You can Telnet to the device for remote management, or use the device as a Telnet client to Telnet to other devices, as shown in Figure 30.

Figure 30 Telnet login

27