HP 200 Unified Threat Management (UTM) Appliance Using the device to log in to a Telnet server

Step	Command	Remarks
		Optional.

4.Enable the user interfaces to support Telnet, SSH, or both of them.

protocol inbound { all ssh telnet }

By default, both Telnet and SSH are supported.

The configuration takes effect the next time you log in.

5. Define a shortcut key for	escape-key { default	Optional.
		By default, pressing Ctrl+C
terminating tasks.	character }
		terminates a task.
6. Configure the type of terminal		Optional.
	terminal type { ansi vt100 }	By default, the terminal display
display.
		type is ANSI.
		Optional.
7. Set the maximum number of lines	screen-length screen-length	By default, up to 24 lines is
to be displayed on a screen.		displayed on a screen.
		A value of 0 disables the function.
8. Set the size of command history	history-command max-size	Optional.
		By default, the buffer saves 10
buffer.	value
		history commands.
		Optional.
		The default idle-timeout is 10
		minutes for all user interfaces.
		The system automatically
9. Set the idle-timeout timer.	idle-timeout minutes [ seconds ]	terminates the user's connection if
		there is no information interaction
		between the device and the user
		within the timeout time.
		Setting idle-timeout to 0 disables
		the timer.
		Optional.
		By default, no automatically
		executed command is specified.
10. Specify a command to be		The command auto-execute
	auto-execute command	function is typically used for
automatically executed when a
	command	redirecting a Telnet user to a
user logs in to the user interfaces.
		specific host. After executing the
		specified command and
		performing the incurred task, the
		system automatically disconnect
		the Telnet session.

Using the device to log in to a Telnet server

You can use the device as a Telnet client to log in to a Telnet server. If the server is located in a different subnet than the device, make sure the two devices have routes to reach each other.

34