Washing dishes | en |
|
|
Programme selection
The most appropriate programme can be identified by comparing the type of crockery, cutlery, etc., as well as the amount and condition of food remains, with the details contained in the wash cycle table.The corresponding programme sequence, duration and consumption details are shown in the right half of the overview. For example:
Use the« normal» 
programme for dishes and utensils which have plenty of food remains stuck on hard.
Earn savings
If only a small number of dishes have been loaded into the dishwasher,selecting a programme that operates at the next lowest temperature will usually be sufficient.
Programme data
The stated programme data are based on standard operating conditions. The values can vary consider- ably according to:
different amounts of dishes temperature of mains water supply pressure of mains water supply ambient temperature fluctuations in mains voltage
Turning on the Appliance
Starting a wash cycle...
Make sure that the plug for the appliance is inserted into the wall socket.
Make sure that the water supply is turned on to full pressure.
Load the dishwasher .
Pour in the detergent.
Press the
Turn the knob located on the right of the control panel until the number or symbol for the cycle setting is aligued with the refrence mark (see the section entitled, program overview).If the knob rightly aligned with the refrence mark you want to choose, you must turn the knob to with the mark of “Reset” .Then back to first step.
After 3 seconds the State Indicator will turn off, the wash cycle will begin.
17