Lenoxx Electronics Optima 3 FS operation manual Removing Photoeye Filter for Cleaning

Page 30

ROUTINE MAINTENANCE

Pull Scraper Rod out & in several times

Scraper Rod pulled out

REMOVABLE BAFFLE PLATES (All Models)

At least once a year, the baffle plates (located in the firebox below exchange tubes) should be removed for cleaning (vacuum out, then reinstall baffle plates)

Removing Baffle Plates

The baffle plates contain keyhole slots allowing the screws to remain in place while removing the baffle. Lift each plate up and forward until screws release through the keyhole slots. Remove baffle plates diagonally through door opening.

PHOTOEYE (Freestanding and Insert)

ENSURE STOVE/INSERT IS COLD BEFORE BEGINNING As a part of normal maintenance, buildup of pellet debris (fines) must be periodically removed from the photoeye filter. This filter can be cleaned by following either proce- dure (A) or (B) on this page:

Note: The photoeye views the fire through a filter. The filter is located at the top of the feed chute near the hopper on the right side. This area should be cleaned periodically to prevent excessive build-up, which may cause the stove to go into “fault” mode.

(A) Cleaning Photoeye Filter Without Removing it:

1.Open the front door to access the feed chute.

2.Remove the buildup on the filter as explained in ei- ther “a” or “b” (note: it may help to use a mirror and a flashlight to view the filter as shown in the following picture):

Mirror

Feed Tube

a.Using a long soft bristled brush (i.e. artists brush), extend it deep into the feed chute and sweep away any pellet fines (on right side).

b.Canned compressed air can also be used to re- move pellet debris from the photoeye filter (use only canned compressed air such as what can be com- monly purchased at a computer or office supply store and some drug stores). Read and follow the instructions on the spray can. Attach the tube (straw) to the nozzle on the canned air (a tube is commonly provided with compressed air. It is simi- lar in use to the tube supplied with WD-40, Lubri- cant). Spray the canned air deep into the feed chute until all “fines” are removed (direct it to the right side).

NOTE: The photoeye lens should be inspected annually and cleaned if necessary as shown in method (B).

(B) Removing Photoeye Filter for Cleaning:

1.Lift off cover plate and turn over (the photoeye is at- tached to the inside surface of cover). Wipe away any dust or debris from the photoeye lens (see following pic- tures).

Photoeye Access Inside Hopper

To access photoeye, open hopper and remove the 3 nuts on cover plate (see picture below).

Using a 11/32"

 

Photoeye Cover

nut driver remove

 

Plate.

the 3 nuts to ac-

 

 

cess photoeye

 

 

and filter.

 

 

PAGE 30

Page 29 Page 31
Image 30
Page 29 Page 31
Contents Installation and Operation Manual Freestanding Insert Pellet Fired StovesImportant Warnings Table of Contents Selecting a Location Planning Your InstallationInstallation / Maintenance Standards Smoke DetectorsFloor Protection Optima 2 FS Top View of Model Optima 2 FSFloor Protection / Hearth Extension Using Clearances Minimum Clearances to CombustiblesOptima 3 FS Minimum Fireplace Firebox Size Fireplace Warning Label Provided in accessory packageMasonry and Factory Built Fireplaces Top ViewModels Optima 2 FS and Optima 3 FS Installation Installation Check ListRemoving Appliance from Pallet Installation Damper Adjustment Damper LocationsDamper Air Control Handle Freestanding Units Model Optima 3 INS Thermostat InstallationModel Optima 3 FS Model Optima 2 FSInstalltion Venting RequirementsVent Termination Site Built Residential Home Chimney Height RequirementsManufactured Mobile Home Chimney Height Requirements Sample Installation Chart Determining Size of Pipe to InstallInstallation Chart Pipe Selection ChartInstalling Your Freestanding Pellet Stove Standard Horizontal Vent InstallationGasket Optima 3 FS Corner Through the Wall Optima 2 FS Corner Through the WallPreferred Installation Vertical Vent Through Roof Exterior Vertical VentVertical Vent Into a Masonry Flue Existing Class a Chimney USA & Canada Direct Connection / Positive Flue Connection Direct Connection Not allowed in CanadaInstalling Optima 3 INS Vent Termination When Liner is UsedCare and Operation Control Board OperationStart-up Sequence of Events Combustion Voltage Trim Steps Fuel Delivery RateAutomatic Operation Lighting Procedure Without IgniterManual Operation Turning OFF Your Pellet StovePower Outage Damper Adjustment GuidelineAutomatic Safety Features Damper Operation All modelsFuel UltraGrateRoutine Maintenance Routine CleaningUltraGrate Burn Grate for All Models Use tool to grab scraper rod Removing Photoeye Filter for Cleaning Photoeye Access Inside HopperClean Photoeye Lens Clean-Out Tee Remove Filter and Wipe CleanASH CLEAN-OUT Ports Checking Door Seal Creosote Removal All Models Door Rope Gasket All ModelsDoor Rope Gasket Window WashSmall Area Paint TOUCH-UP Rear Stove Compartment All ModelsMotor Lubrication Back View Side ViewFuel delivery and burn times will vary depending On size and type of fuel used. Estimated heat inputBased on fuel value of 8400 BTU per lb 23 5/8 TOP ViewComponent Definitions Wiring Diagram Troubleshooting Qualified Technicians Only Troubleshooting Qualified Technicians Only Troubleshooting Qualified Technicians Only Replacement Parts List Electrical Parts Item # Description Stove ModelFirebox Parts Item # Description Stove Model Auger System Components Item # Description Stove ModelMisc Item # Description Stove Model Replacement Parts Diagrams Replacement Parts Diagrams Replacement Parts Diagrams Replacement Parts Diagrams Optional Accessories Diagrams Optional Accessories Item # Model Description Stove ModelInstallation Tips Simple Operating Instructions Label SAFETY/LISTING Label Model Optima 2 FS SAFETY/LISTING Label Model Optima 3 FS and Optima 3 INS Service and Maintenance LOG Ownership RecordsWest Taft Avenue Orange, CA

Optima 3 FS specifications

Lenoxx Electronics has established itself as a reputable brand in the audio equipment industry, and their Optima 3 FS model is a perfect illustration of their commitment to quality and innovation. Designed for both casual listeners and audiophiles alike, the Optima 3 FS combines advanced technology with user-friendly features, making it a compelling choice for anyone looking to enhance their audio experience.

One of the standout features of the Optima 3 FS is its outstanding sound reproduction capabilities. The speakers are engineered with high-quality drivers that deliver clear and balanced audio across a wide frequency range. Whether you’re listening to music, watching movies, or playing video games, the Optima 3 FS promises an immersive auditory experience that captures the essence of sound.

The model also boasts Bluetooth connectivity, allowing users to pair their smartphones and other devices effortlessly. This wireless feature provides convenience, enabling you to play music from your playlists or streaming services without the hassle of tangled cords. Additionally, the Optima 3 FS is equipped with USB and AUX inputs, ensuring compatibility with various audio devices.

Another significant characteristic of the Optima 3 FS is its compact and stylish design. The sleek finish and modern aesthetics make it an attractive addition to any home décor. Its compact size doesn’t compromise sound quality, making it perfect for smaller spaces where traditional large speakers might not fit.

The user interface is designed to be intuitive, featuring easy-to-use buttons and a clear display that allows for seamless navigation through functions and settings. Furthermore, the Optima 3 FS incorporates a remote control, providing added convenience to adjust volume, skip tracks, or change modes from a distance.

In terms of energy efficiency, the Optima 3 FS is designed to consume less power without sacrificing performance, making it an environmentally friendly choice. This model is also built with durability in mind, featuring robust components that ensure long-lasting use.

In summary, the Lenoxx Electronics Optima 3 FS stands out with its exceptional sound quality, versatile connectivity options, stylish design, and user-friendly features. It caters to a broad audience, from casual listeners to sound enthusiasts, making it a noteworthy addition to the realm of home audio solutions.
Top Page Image Contents