Lenoxx Electronics Optima 3 FS operation manual Troubleshooting Qualified Technicians Only

Page 40

TROUBLESHOOTING Qualified Technicians Only

Unplug Appliance Before Performing Any Troubleshooting or Maintenance

PROBLEM

CAUSE(S)

SOLUTIONS

4. Blowers will not

There is no power to the stove.

Check that the stove is plugged in to the wall outlet.

operate when the

There is no power to the control board.

Check to see if your circuit breaker has tripped.

start button is de-

 

 

pressed.

 

Check the wire connections on the high limit disc and control board.

 

 

 

5. There is soot or fly

The window is being cleaned when the

Turn down the room air blower or turn off stove before cleaning to

ash in the house.

stove is operating.

prevent dispersion of ash and soot into the room.

 

 

 

There is leakage at the joints between

Seal up any leaks in the exhaust system with room temperature

 

the exhaust blower, connection or ex-

vulcanizing silicone sealer (High Temperature RTV).

 

haust pipe connections. This will be

 

 

evidenced by dust on the impeller of

 

 

the room air blower, and in the heat

 

 

exchanger area.

DO NOT use a standard household vacuum or “shop vac” as the

 

 

 

The vacuum cleaner is leaking.

filters will leak the fine particles of ash. Clean the stove with an ap-

 

 

proved ash vacuum ONLY.

6. Stove acts as if a

Excessive sun light may be shining

Block excessive sunlight. Call authorized Lennox Hearth Products

fire is present when

directly into firebox from window.

dealer if problem persists.

 

 

there is not a fire in

 

 

the grate.

 

 

7. Stove will not light.

The igniter element may have failed.

Check igniter element fuse in rear stove compartment. Call your

 

 

authorized Lennox Hearth Products dealer. See alternate manual

 

 

lighting procedure

 

There is not enough pellets in the

Prime the feed system (see Initial Start-Up, page 24).

 

grate.

 

8. Fault

Photoeye not detecting flame.

Check connection at control board following yellow wires to all con-

 

 

nectors.

 

Stove has run out of fuel.

Refill hopper.

 

A disk has tripped / pressure switch.

Blower intake, exhaust passages and / or venting system needs

 

 

cleaning (follow routine and annual maintenance procedures).

 

 

If this does not correct the problem contact your local authorized

 

 

Lennox Hearth Products dealer.

9. Blowers run con-

Wire harness and/or control board has

Contact your local authorized Lennox Hearth Products dealer.

tinuously

been damaged – unplug stove and

 

 

contact dealer.

 

 

 

 

10. All lights on con-

When using a thermostat. Thermostat

The lights on the control board remain on even when the thermostat

trol are on but noth-

not calling for heat.

is not demanding heat. When the thermostat demands heat the

ing happens

 

stove will begin to operate.

 

 

 

If not using a thermostat - Check ther-

Ensure that the thermostat jumper at terminal block is installed and

 

mostat jumper

making good contact.

PAGE 40

Image 40
Contents Installation and Operation Manual Freestanding Insert Pellet Fired StovesImportant Warnings Table of Contents Planning Your Installation Installation / Maintenance StandardsSelecting a Location Smoke DetectorsFloor Protection Optima 2 FS Top View of Model Optima 2 FSFloor Protection / Hearth Extension Using Minimum Clearances to Combustibles ClearancesOptima 3 FS Fireplace Warning Label Provided in accessory package Masonry and Factory Built FireplacesMinimum Fireplace Firebox Size Top ViewModels Optima 2 FS and Optima 3 FS Installation Check List InstallationRemoving Appliance from Pallet Installation Damper Locations Damper AdjustmentDamper Air Control Handle Freestanding Units Thermostat Installation Model Optima 3 FSModel Optima 3 INS Model Optima 2 FSInstalltion Venting RequirementsSite Built Residential Home Chimney Height Requirements Vent TerminationManufactured Mobile Home Chimney Height Requirements Determining Size of Pipe to Install Installation ChartSample Installation Chart Pipe Selection ChartStandard Horizontal Vent Installation Installing Your Freestanding Pellet StoveGasket Optima 3 FS Corner Through the Wall Optima 2 FS Corner Through the WallExterior Vertical Vent Preferred Installation Vertical Vent Through RoofVertical Vent Into a Masonry Flue Existing Class a Chimney USA & Canada Direct Connection / Positive Flue Connection Direct Connection Not allowed in CanadaInstalling Optima 3 INS Vent Termination When Liner is UsedCare and Operation Control Board OperationStart-up Sequence of Events Combustion Voltage Trim Steps Fuel Delivery RateLighting Procedure Without Igniter Manual OperationAutomatic Operation Turning OFF Your Pellet StoveDamper Adjustment Guideline Automatic Safety FeaturesPower Outage Damper Operation All modelsFuel UltraGrateRoutine Cleaning Routine MaintenanceUltraGrate Burn Grate for All Models Use tool to grab scraper rod Removing Photoeye Filter for Cleaning Photoeye Access Inside HopperRemove Filter and Wipe Clean Clean Photoeye Lens Clean-Out TeeASH CLEAN-OUT Ports Door Rope Gasket All Models Door Rope GasketChecking Door Seal Creosote Removal All Models Window WashRear Stove Compartment All Models Small Area Paint TOUCH-UPMotor Lubrication Back View Side ViewOn size and type of fuel used. Estimated heat input Fuel delivery and burn times will vary dependingBased on fuel value of 8400 BTU per lb 23 5/8 TOP ViewComponent Definitions Wiring Diagram Troubleshooting Qualified Technicians Only Troubleshooting Qualified Technicians Only Troubleshooting Qualified Technicians Only Replacement Parts List Electrical Parts Item # Description Stove ModelAuger System Components Item # Description Stove Model Firebox Parts Item # Description Stove ModelMisc Item # Description Stove Model Replacement Parts Diagrams Replacement Parts Diagrams Replacement Parts Diagrams Replacement Parts Diagrams Optional Accessories Diagrams Optional Accessories Item # Model Description Stove ModelInstallation Tips Simple Operating Instructions Label SAFETY/LISTING Label Model Optima 2 FS SAFETY/LISTING Label Model Optima 3 FS and Optima 3 INS Service and Maintenance LOG Ownership RecordsWest Taft Avenue Orange, CA

Optima 3 FS specifications

Lenoxx Electronics has established itself as a reputable brand in the audio equipment industry, and their Optima 3 FS model is a perfect illustration of their commitment to quality and innovation. Designed for both casual listeners and audiophiles alike, the Optima 3 FS combines advanced technology with user-friendly features, making it a compelling choice for anyone looking to enhance their audio experience.

One of the standout features of the Optima 3 FS is its outstanding sound reproduction capabilities. The speakers are engineered with high-quality drivers that deliver clear and balanced audio across a wide frequency range. Whether you’re listening to music, watching movies, or playing video games, the Optima 3 FS promises an immersive auditory experience that captures the essence of sound.

The model also boasts Bluetooth connectivity, allowing users to pair their smartphones and other devices effortlessly. This wireless feature provides convenience, enabling you to play music from your playlists or streaming services without the hassle of tangled cords. Additionally, the Optima 3 FS is equipped with USB and AUX inputs, ensuring compatibility with various audio devices.

Another significant characteristic of the Optima 3 FS is its compact and stylish design. The sleek finish and modern aesthetics make it an attractive addition to any home décor. Its compact size doesn’t compromise sound quality, making it perfect for smaller spaces where traditional large speakers might not fit.

The user interface is designed to be intuitive, featuring easy-to-use buttons and a clear display that allows for seamless navigation through functions and settings. Furthermore, the Optima 3 FS incorporates a remote control, providing added convenience to adjust volume, skip tracks, or change modes from a distance.

In terms of energy efficiency, the Optima 3 FS is designed to consume less power without sacrificing performance, making it an environmentally friendly choice. This model is also built with durability in mind, featuring robust components that ensure long-lasting use.

In summary, the Lenoxx Electronics Optima 3 FS stands out with its exceptional sound quality, versatile connectivity options, stylish design, and user-friendly features. It caters to a broad audience, from casual listeners to sound enthusiasts, making it a noteworthy addition to the realm of home audio solutions.