Installation
Caution: Before starting the installation, turn the power off at the
circuit breaker.
If you want to use the Manual Override feature you will need to install the fixture on a circuit controlled by a switch. The lamps are packed in boxes, inside the lampheads. Open the lampheads by removing the screws at the top. Use a clean cloth or the foam packing around the lamps to keep your fingers off the lamps. Install the lamps in the right side of the sockets first, then the left. Close the lampheads and continue the installation as shown below.
Wall Mount | Eave Mount |
❒Loosen the thumbscrews holding the sensor head and lampheads.
❒Adjust the various parts so that the fixture looks similar to this illustration.
❒Finger tighten the thumbscrews at this time.
❒Loosen the thumbscrews holding the sensor head and lampheads.
❒Adjust the various parts so that the fixture looks similar to this illustration.
❒Finger tighten the thumbscrews at this time.
CAUTION: To Avoid Fire Or Burn Hazards:
•Allow fixture to cool before touching. The bulb and the fixture operate at high temperatures.
•Keep fixture at least 3" (76 mm) from combustible materials. Do not aim at objects closer than 3' (1 m).
•Use only type T 250W (max.) tungsten halogen 120 VAC lamps.
- - |