Alarm Time Setting
The
Initial Alarm Time
Press and hold [ALM] (Alarm)
“AM 12:00” is displayed when the alarm is not adjusted.
APM DISP
CLK
PWR BAND MODE
|
|
|
|
|
| ALM |
|
|
|
| LOUD | ||
VOL |
|
|
|
|
| MUTE |
PUSH |
|
|
|
|
| TUNE |
SEL/SAT |
|
|
|
|
| |
BASS/TREB |
| DISC | CD SCAN | RPT | RDM | SEEK |
|
|
|
|
| SCAN | |
BAL/FADER | 1 MTL | 2 NR 3 TPS | 4 REP | 5 SKP | 6 |
|
|
| |||||
ILL
Alarm Time Setting
q Press and hold [ALM] (Alarm) and do not release to set alarm time. Display blinks and the alarm time setting mode is activated.
(blink.)
Hours
w Press [{] to set the hour.
(Hours set.)
[{] (Hours) | [}] (Minutes) |
Alarm Operation
•Alarm is switched to ON or OFF each time [ALM] is pressed.
•When the alarm is switched to ON, the alarm will sound at the set alarm time.
Turning off the Alarm Sound
The alarm will turn off automatically after 90 seconds. Otherwise, press [ALM] once.
Alarm output Volume Selection
You can select ALARM VOL 1 (or VOL 2) by pressing [ALM] in sequence and the display will show as follows.
Minutes
e Press [}] to set the minute.
(Minutes set.)
r Once the alarm time has been set, release [ALM].
Note: Press and hold [{] or [}] to change numbers rapidly.
Alarm Time Reset
When you want to reset the alarm time, repeat steps q to r.
8
a 
a OFF
Cautions:
•Be careful not to set wrong alarm time, otherwise, the alarm may sound while driving.
•If the alarm is set, be sure to check the set alarm time by pressing [CLK].
•If volume is set at “0” level, the output volume will be muted. (Even when ALARM is acting.)