KitchenAid KBAU362V, W10118096B cm Access DoorReversal Style 2Only, A C B, To Replace the Door

Page 9
18"(45.7 cm) Access DoorReversal -

To Replace the Door:

1.Slide the door hinges into the slots in the frame and push in to seat hinges.

2.Locate the 4 hinge screw mounting holes through the top and bottom of the frame and replace the 4 screws. Do not tighten.

3.Check and adjust door then tighten the screws. See “Access Door Alignment - Style 2 Only.”

4.Repeat steps 1 through 3 for the other door if necessary.

18"(45.7 cm) Access DoorReversal -

Style 2Only

The 18" (45.7 cm) access door can be reversed from a right-side opening to a left-side opening. This must be done prior to mounting the door assembly into the cabinet opening.

To remove the access door from the frame:

1.Lay the access door assembly on a covered surface.

2.Open the door to the full open position.

3.Locate and remove the 4 door hinge mounting screws in the door frame.

A

B

4.Pull the door away from the center to slide the door hinges out of the hinge slots in the frame.

5.Lay the front face of the access door on a covered surface.

6.With a #3 Phillips screwdriver, remove the 4 hinge screws from the door.

A

C

B

A. Top hinge screws (2)

B. Bottom hinge screws (2)

C. Hinges (2)

7.With a #2 Phillips screwdriver, remove the screws from around the perimeter of the inner door.

8.Remove the inner door panel and slide the 2 door hinges out of the hinge slots in the door.

9.Replace the door hinges by sliding them into the hinge slots on the opposite side of the door.

10.Rotate the inner door panel 180° and place the inner door panel so that the hinge slots in the inner door slide over the hinges.

A. Top door hinge mounting screws (2 - underside of frame)

B. Bottom door hinge mounting screws (2)

9

Image 9
Contents OUTDOOR ACCESS DOORS W10118096BInstallationInstructionsandUse&CareGuide PORTES D’ACCÈS D’EXTÉRIEURTABLE DES MATIÈRES TABLE OF CONTENTSINSTALLATION REQUIREMENTS OUTDOOR ACCESS DOORS SAFETYDANGER Tools and PartsAccess Door Style 1 external hinge pin ProductDimensionsSingle Access Doors Double Access DoorsK KF M CabinetCutout DimensionsCutout Dimensions - Built-inGrill Access DoorAlignment - Style 2Only INSTALLATION INSTRUCTIONSInstallAccessDoor -Style1 externalhingepin Install Access Door- Style2internalhingeStyle 1 external hinge pin To Remove the Door Access DoorRemovalTo Replace the Door Style 2 internal hinge To Remove the DoorA C B 1845.7 cm Access DoorReversal Style 2OnlyTo remove the access door from the frame To Replace the DoorAttachCondiment Shelf- Styles1 and2 A C BTo replace the door into the frame ASSISTANCE OR SERVICE ACCESS DOORS CAREGeneral Cleaning If you need replacement partsLIMITED WARRANTY KITCHENAID OUTDOOR PRODUCT WARRANTYITEMS EXCLUDED FROM WARRANTY This limited warranty does not coverPage SÉCURITÉ DES PORTES DACCÈS DEXTÉRIEUR EXIGENCES DINSTALLATIONDANGER AVERTISSEMENT Outillage et piècesDimensions duproduit Dimensions delouvertureàdécouperdansleplacard D H AK KF M Taille du gril Installation delaportedaccès INSTRUCTIONS D’INSTALLATIONAVERTISSEMENT Alignementdelaportedaccès Style2uniquementStyle 1 axe de charnière externe Dépose delaportedaccèsDépose de la porte Remise en place de la porteStyle 2uniquement Inversiondela porte d’accèsde18 45,7 cmRemise en place de la porte Dépose de la porte d’accès du châssis de porteFixationdel’étagère àcondiments - Styles1et A C BRemise en place de la porte dans le châssis ENTRETIEN DES PORTES DACCÈS ASSISTANCE OU SERVICENettoyage général AuCanadaKITCHENAID GARANTIE DES PRODUITS POUR USAGE EXTÉRIEURGARANTIE LIMITÉE LES PIÈCES POUR LES GRILS UNIQUEMENT11/08 W10118095B2008. All rights reserved Tous droits réservés