Samsung SDM-160P, SDM-160MP, SDM-090P manual Connecting to Alarm Sensor

Page 16

Digital Multiplexer

4.Connecting to ALARM SENSOR

1.Connect the ALARM terminal on the Unit’s Rear Panel to the SENSOR CORRESPONDING TO camera number.

2.Connect grounding wires.

3.Connect the HOT terminal on the Unit’s Rear Panel to the ALARM IN terminal on the VCR.

4.Connect the COLD terminal on the Unit’s Rear Panel to the COM terminal on the VCR.

5.Connect the A/R terminal on the Unit’s Rear Panel to the RESET terminal on the VCR.

CAUTIONS

Depending on the kinds of TIME LAPSE VCR, the name of REC TRIGGER OUT terminal may be different, so be sure to connect after checking its name.

ALARM Externa

Conecte a dispos

3-3

Image 16

Contents Digital Multiplexer Important Safeguards Iii Contents Appendix B Checking Points in Trouble Introduction IntroductionName of parts and Function Move → Rear panel Preparing for the Installation Physical & EnvironmentalPrecautions when Installing Digital Multiplexer Unpacking Connecting to normal VCR and Monitor Connecting to Other DevicesConnecting to S-VHS VCR and S-VHS Monitor Connecting to Time Lapse VCR Connecting to Alarm Sensor Remote Control by connecting to PC AsciiRemote Control using SSC-1000RS-485 Monitor OUT Control@ Spot OUT Control Spot OUT ControlWhen desiring to see in the live screen/replay screen When desiring to see in the Triplex screenBasic Method to use Initial operationWhen desiring to see in the Full screen When desiring to see in the division screenWhen desiring to see automatic sequential conversion screen When desiring to see in the zoom screen When desiring to see the stop screenFull Mode 2TIMES Zoom Times Zoom When desiring to see in the record screen When desiring to see in the PIP screenWhen desiring to see output of VCR as it is Setting of Program Menu Record setting of each cameraREC OUT SET Type TLV Duty SET Reservation OFFREC Reservation Start Time REC Duty SET CH1 CH2 CH3 CH4 CH5 CH6 CH7 CH8 CH9END Time Setting of display mode Sequence Loss Detect Loss Info Alarm Info Motion InfoALL PB Display ALL Spot OUT Cvbs PIP SizeAlarm S/W Time SequenceSetting of title by channel CH15 onIjklmnopqrstuvwxyz Title SETDATE/TIME SET Display Type Setting of alarm Setting of motionList Update OFF ↔ on XxxxxSensitivity OFF ↔ LOW ↔ Medium ↔ High Motion OUT OFF ↔ onSystem setting Password ChangePassword Check OFF Alarm Buzzer Loss Buzzer Summer Time Baud RatePassword Change Password Check NEW Password Confirm +++++++++++++++++ + - - - - +Time Lapse record mode Normal record modeRecording Weight value REC Duty record Alarm weight value recordReservation record REC DutyAlarm occurrence conditions Alarm releaseAlarm record Alarm signal standardOperation in video loss Alarm/Loss list referenceOperation in motion detection Appendix a Specifications Image inputOutside Drawing When record is not done Appendix B Checking points in trouble

Related manuals

Manual 69 pages 50.93 Kb