Digital Multiplexer
5. Setting of alarm
Set operation when alarm occurs.
The following screen is displayed if pressing the “ENTER” button with the blinking indication placed at the “5.ALARM SET” by pressing the “MOVE” button on the main menu screen:
[ALARM SET]
HOLD TIME | 01 | MIN |
| 00 | SEC |
REC TYPE | NOR |
|
ALARM INPUT OFF
-The blinking character moves if pressing “→
-The setting value is changed if pressing “ →
HOLD TIME : 00 ~ 30 (MIN) 00 ~ 59 (SEC)
→ | ” button. |
”, “ |
”, “→ ” button.
✴The 00 MIN 00 SEC means a manual mode (perform operation for the time the alarm input enters into).
REC TYPE: NOR ↔ TL V
•Set a record mode when alarm occurs. ALARM INPUT: OFF ↔ N.O ↔ N.C ↔OFF
•Set according to the output of alarm sensor connected to the alarm input terminal on the rear side of this unit.
•OFF: When no alarm input exists.
•N.O: When alarm input is ACTIVE LOW.
•N.C: When alarm input is ACTIVE HIGH.
- The changed setting value is stored if pressing the “SET” button and you can return to the main menu.
6. Setting of motion
Set motion detection and operation.
The following screen is displayed if pressing the “ENTER” button with the blinking indication placed at the “6.MOTION SET” by pressing the “MOVE” button on the main menu screen:
[MOTION SET]
SENSITIVITY | OFF | |
AREA | SET | CH1... |
MOTION OUT | OFF | |
LIST | UPDATE | OFF |
BUZZER | OFF | |