5.Align the flow control lever so that the lever is pointing up (refer to illustration).
6.Slide the flow control lever and concealing plate over the flow control hub.
7.Latch the top of the concealing plate over the top of the backplate.
Note! You will need to push the concealing plate up and over the lip on top of the backplate (refer to illustration).
8.Clip the bottom of the concealing plate into position.
9.Align the temperature control knob with the hub and push the knob onto the concealing plate.
Note! If the finished wall thickness is less than 8 mm the temperature hub spacer will need to be removed, refer to section: ‘Commissioning’.
Note! The Thermostatic Shower Control is preset to approximately 43°C at the factory. If adjustment is required, refer to section:
‘Commissioning’.
Push up and Latch over the Top of the Backplate 
Align Flow Lever as Shown
‘Click’ into Position
20