Kohler Discovery manual Connections, Thermostatic Shut-down

Page 7

Connections

Standard connections are: Hot-Left,Cold-Right,Top-Outlet,if reversed inlets are

required refer to sections: ‘Installation’ and ‘Reversed Supplies’.

Inlets: 15 mm Compression.

Outlet: 15 mm Compression.

Thermostatic Shut-down

Thermostat will shut off Hot Supply Within 2 Seconds if Cold Supply Fails. (Achieved only if the hot supply temperature is greater than 10°C above the set blend temperature).

Image 7

Contents These instructions are to be left with the user Contents Introduction Safety WarningsPack Contents Dimensions Flow Rates SpecificationsTemperatures PressuresThermostatic Shut-down ConnectionsGas heated system Installation RequirementsKey to symbols Gravity fed systemHot water system thermal store Mains pressurised instantaneousPumped system General InstallationInstallation Methods Mm Max Outlet Pipe BIR Page Page Refer to section ‘1. Solid Wall or Page Fit the securing brackets to the shower valve M5 Fixing Holes Securing Screws Control Assembly ‘Commissioning’ Reversed Supplies Commissioning Maximum Temperature SettingOperation Symptom CAUSE/RECTIFICATION Fault DiagnosisCleaning Filters MaintenanceLubricants Spare Parts Page Customer Service