Samsung VCU8563S1R/XAC manual Check Rotating Floor Brush and Drive Belt, Replace Drive Belt, EN-10

Page 10

Unplug cleaner from electrical outlet.

Unplug cleaner from electrical outlet.

Place handle in Low position and turn vaccum cleaner over so bottom side is up.

Remove the eight screws as shown with a screwdriver.

Turn over the cleaner again, and lift the Cover-Brush off.

Remove the eight screws, and lift the Brush Cover off. Grasp Rotating Floor Brush at both ends and lift.

Clean strings, hair and other debris from Rotating Floor Brush, paying particular attention to brush ends.

Clean strings, hair and other debris from Motor Pulley and Drive Belt areas.

Check Drive Belt carefully for wear, cuts or stressed areas.

Maintenance

Check Rotating Floor Brush and Drive Belt

1

2

3

4

5

6

7

8

9

10 Check Air Passageway for obstructions. Remove debris from this area.

Replace Drive Belt

1

2 With Rotating Floor Brush removed from vaccum cleaner(Step1-6 of Check Rotating Floor and Drive Belt) grasp old Drive Belt and remove from Motor pully. Discard old Drive Belt.

3 Place new Drive Belt over motor pulley and stretch other end over rotating Floor Brush in the space between the bristles.

4 Place ends of rotating Floor Brush down into slots on sides as shown.

5 Turn rotating Floor Brush by hand several times in direction of motor pulley, if properly installed, Drive Belt will center itself.

6 Reposition Brush cover and eight screws. Tighten screws securely. Snap end of Brush cover into place.

EN-10

Image 10

Contents EN Vacuum Cleaner Important Safety Instructions Assembled Vacuum Cleaner Parts Vacuum Cleaner DescriptionEN-3 Checking Parts Vacuum Cleaner AssemblyAttaching Handle to cleaner Attach Handle to Dirt cupSnap the hose into the hose clip as shown Attaching the Hose and ToolsEN-5 Operation Power ControlBrush roll switch Handle ReleaseCleaning Tool Attachments Powerfoot Height AdjustmentEdge Cleaning Feature Circuit BreakerCarrying Cleaner Power Cord ArrangementTransporting Cleaner Cord ClipCleaning Dirt cup MaintenanceDirt-Cup Full or Filter clogged Indicator Cleaning the Case-FilterReplace Drive Belt Check Rotating Floor Brush and Drive BeltEN-10 Headlight Replacement Clearing ClogsTurbine Brush Replace Agitator brush roll Replace beltOptional accessories EN-13Possible solution TroubleshootingProblem EN-14Instructions Directives DE Sureté Importantes FR-2Assemblage de l ’aspirateur FR-3Assemblement de la poignée à l’aspirateur Assemblage de l’aspirateurVérification des pièces Assemblement de la poignée au contenant de poussièreAssemblement du boyau et accessoires FR-5Bouton d’inclinaison de l’aspirateur FonctionsInterrupteur arrêt/départ variabilité de succion Interrupteur du rouleauNiveaux d’ajustement du rouleau Nettoyage avec les accessoiresCircuit Nettoyage à la bordureManoeuvrabilité de l’aspirateur Corde d’alimentationAttache pour corde d’alimentation Transporter votre aspirateurNettoyer le contenant de poussière EntretienContenant de poussière plein, indicateur du filtre bouché Nettoyer la cage du filtreVérification du rouleau et de la courroie Remplacer la courroieObstructions Remplacer l’ampouleBalai à air Remplacer le rouleau Accessoires optionnels FR-13Problèmes Solution possibleProblème