Samsung VCU8563S1R/XAC manual Turbine Brush Replace Agitator brush roll, Replace belt

Page 12

Maintenance

Turbine Brush

*Replace Agitator brush roll

1 Remove tool from hose and turn it so bottom face up. Push up the hook on either side of tool and remove bottom plate.

2 Remove agitator including end plates and discard.

3 Inspect belt to ensure that it is in good condition, if belt is cracked, gouged, or brocken. Replace it(see following section).

4 With curved ends down, slide end plates of brush roll into slots on tool.

5 To replace bottom plate, insert the four tabs on edge of bottom plate into slots on front of tool. Pivot bottom plate down and snap closed.

*Replace belt

Grasp turbin and pull firmly to remove.

Remove a screw, and lift the cover belt off.

Remove belt from turbin pulley. Replace with new belt.

4 With flat sides of turbin retainers pointing down, slide retainers into grooves in tool housing and snap into place.

5 Replace brush roll and bottom plate.

EN-12

Image 12

Contents EN Vacuum Cleaner Important Safety Instructions Vacuum Cleaner Description Assembled Vacuum Cleaner PartsEN-3 Vacuum Cleaner Assembly Attaching Handle to cleanerChecking Parts Attach Handle to Dirt cupAttaching the Hose and Tools Snap the hose into the hose clip as shownEN-5 Power Control Brush roll switchOperation Handle ReleasePowerfoot Height Adjustment Edge Cleaning FeatureCleaning Tool Attachments Circuit BreakerPower Cord Arrangement Transporting CleanerCarrying Cleaner Cord ClipMaintenance Dirt-Cup Full or Filter clogged IndicatorCleaning Dirt cup Cleaning the Case-FilterCheck Rotating Floor Brush and Drive Belt Replace Drive BeltEN-10 Headlight Replacement Clearing ClogsTurbine Brush Replace Agitator brush roll Replace beltOptional accessories EN-13Troubleshooting ProblemPossible solution EN-14Instructions Directives DE Sureté Importantes FR-2Assemblage de l ’aspirateur FR-3Assemblage de l’aspirateur Vérification des piècesAssemblement de la poignée à l’aspirateur Assemblement de la poignée au contenant de poussièreAssemblement du boyau et accessoires FR-5Fonctions Interrupteur arrêt/départ variabilité de succionBouton d’inclinaison de l’aspirateur Interrupteur du rouleauNettoyage avec les accessoires CircuitNiveaux d’ajustement du rouleau Nettoyage à la bordureCorde d’alimentation Attache pour corde d’alimentationManoeuvrabilité de l’aspirateur Transporter votre aspirateurEntretien Contenant de poussière plein, indicateur du filtre bouchéNettoyer le contenant de poussière Nettoyer la cage du filtreVérification du rouleau et de la courroie Remplacer la courroieObstructions Remplacer l’ampouleBalai à air Remplacer le rouleau Accessoires optionnels FR-13Solution possible ProblèmesProblème