CLEANING THE DEBRIS FILTER
We recommend cleaning the debris filter when water does not drain well or the “ND” error message is displayed.
1.Open the filter cover by pressing and pulling the handle of the filter cover with your finger.
2. Unscrew the drain cap by turning it | Step 1 | Step 2 |
counterclockwise. |
|
|
3. Hold the cap on the end of the drain tube and slowly pull it out about 6 inches (15 cm) and drain off all the water.
4.Remove the debris filter cap.
5.Wash any dirt or other material from
the debris filter. Make sure the drain pump propeller behind the debris filter is not blocked.
6. Replace the debris filter cap.
7. Replace the filter cover.
04 Maintaining your washer
Maintaining your washer _19