Samsung AP0AS0ANXSG manual Troubleshooting

Page 20

Troubleshooting

Refer to following chart if the air conditioner operates abnormally. This may save time and unnecessary expenses.

PROBLEM

SOLUTION

 

 

 

• Check power status and then operate the air conditioner again.

The air conditioner does not work

• Check whether the power plug is connected correctly or the auxiliary power

switch is switched on.

at all.

• If the air conditioner is switched off by the Timer function, press theOn/Off

 

 

button.

 

 

The temperature adjustment is not

• Temperature adjustment is not available when the Fan mode is selected.

working.

 

 

 

Fan speed adjustment is not

• Check if you have selected Auto/Dry/Turbo mode. In these modes, fan speed is

working.

set to Auto and you cannot adjust the fan speed.

 

 

 

• Replace the exhausted batteries with new ones.

 

• Do not block the remote controller receiver.

Remote controller does not work.

• If the remote controller is used near strong light(3-wavelength fluorescent

 

light, neon sign etc.), the remote controller may not work due to the electronic

 

jamming signal

 

 

 

• Check if the set temperature is higher than the current temperature. Press the

 

Temp + or - button on the remote controller to set the temperature lower than

 

the current temperature.

 

• Check if you have selected Fan mode. In this mode, Cool air will not come out in

 

Fan mode therefore select Auto/Cool/Dry mode.

 

• Check if the air filter is blocked by dirt. If there is a lot of dust on the Air filter,

 

cooling performance may decrease. Clean them frequently.

 

• Check if the outdoor unit is covered or installed near the obstacle. Take the cover

Cool air does not come out of the

off and take the obstacle away.

air conditioner.

• Check if the indoor unit is installed in a place with direct sunlight. Close the

 

curtain or blind to cover the sunlight.

 

• If the doors or windows are open, it may cause bad cooling performance. Close

 

the doors and windows.

 

• If the air conditioner has just been turned on or the indoor temperature reaches

 

the desired temperature, only fan will operate around 3 minutes for the product

 

protection.

 

• Check if the pipe length is too long. When the pipe length exceeds maximum

 

allowable pipe length, cooling performance may decrease.

 

 

ENGLISH

19

PAC_아프리카 중동향AP80S0A_IBIM_34514A-02_EN.indd 19

2015-04-23 오후 2:18:55

Image 20
Contents Questions or COMMENTS? 08000-7267864Air Conditioner Thank you for purchasing this Samsung productFeatures of your new air conditioner ContentsSafety precautions Important safety symbols and precautionsXXFailing to do so may result in electric shock or fire XXThis may result in electric shock or fireFor Power Supply XXWhen there is fire, this may cause spread of fireXXThis may result in electric shock Do not place objects or devices under the indoor unitDo not operate the appliance with wet hands Do not clean the inside of the air conditioner by yourself Do not drink the water from the air conditionerUsing outdoor unit Checking the auxiliary power switchOperational temperature and humidity range Auxiliary power switch Elcb Earth Leakage Circuit BreakerTo open the panel Viewing the partsMain parts Locking the control panel Control panel and the displayUsing the air conditioner with the control panel Installing the batteries Checking the remote controllerRemote controller button Basic operation CoolAuto DryPress Button to adjust the desired temperature Press Button to start the operation of the air conditionerAdjusting the air flow direction Turbo operationPress Operation will operate for 30 minutesTimer function Press the button when the air conditioner is onSmart saver operation You can turn the air conditioner off at your desired timeCleaning and maintaining the air conditioner Cleaning the indoor unitCleaning the outdoor unit heat exchanger Service centerCleaning the air filter Maintaining the air conditioner Periodical checksTroubleshooting Function See if the timer is already setClean the air filter if it is dirty If the message General information Installing the unitAccessing its internal components Power supply line, fuse or circuit breaker Do not install the air conditioner in following placesMake sure that you earth the cables Complete, electric shock or fire may occurPreparation for installation When moving with a craneWhen moving with a fork lift Indoor outdoor unit type and combinationDeciding on where to install the product Indoor unitFix the wire on the ground Wires on the wallOutdoor unit Personal injury or property damageSelecting appropriate location for installation Wear protective goggles and mask before spraying When there are no tall obstacles around the outdoor unit When the air outlet is opposite the wallWhen 3 sides of the outdoor unit are blocked by the wall Space requirementsPipe length between the indoor and the outdoor unit When there is tall obstacle around the outdoor unitWhen installing 1 outdoor unit Preparing the installation Installing duct for horizontal exhaust dischargeInstalling the outdoor unit in harsh environments When installing ductsInstalling indoor unit Installing outdoor unit AP80S0XOutdoor unit base mount and anchor bolt position Connecting the pipes Refrigerant piping workRemoving the connection pipe InjuryOutdoor unit pipe connection AP80S0X Keep the pipe length as short as possibleSelecting refrigerant pipe Temper grade and minimum thickness of the refrigerant pipeModel name Liquid side mm Gas side mm Outer diameter mm/inch Minimum thickness mm Temper gradeDirection of the pipe when brazing Storing refrigerant pipeNitrogen flushing brazing Stored place Stored time Sealing typeCorrect Inclined Damaged surface Cracked Uneven thickness Cutting or flaring the pipesOuter diameter Dmm Connecting the drain hose Tightening flare connection partPipe bending Piping materialSelecting the insulator of the refrigerant pipe Insulating refrigerant pipeFfPipe insulation To prevent moisture from enteringWiring work Electrical workPower supply and wire specification 0Not includedConnecting power and communication cable AP80S0A / AP0AS0ASelecting solderless ring terminal Screw Tightening torque kgf∙cm Connecting the power terminalFixing the power cable Grounding the power cable FfGrounding must be done by installation specialistWhen using the exclusive terminal for grounding Grounding workGrounding work procedure If you are using the grounding on the switching boardFfMake sure that grounding work is done in below procedure Procedure ExplanationGas leak test and vacuum drying Allowable refrigerant pipe length How to add refrigerantRefrigerant charging Setting the option switches & function keys Setting the option switch of the indoor unitSetting the main PCB option K1 K2 K3 K4Setting the outdoor unit KEY K2 Number of pressingSegment display Display PressingCheck lists after completing the installation Trial operation Inspection before trial operationTrial operation Make sure that all the indoor units are properly operatingError diagnosis Error displayError display Error description LED displayHow to connect your extended power cables Twist the wire cores together and push it in to the sleeveInsulation tape

AP0AS0ANXSG specifications

The Samsung AP0AS0ANXSG is a cutting-edge appliance that showcases the brand's commitment to innovation and excellence in technology. As a prominent player in the consumer electronics market, Samsung continues to push the boundaries of what is possible, and the AP0AS0ANXSG is a testament to that ethos.

One of the standout features of the AP0AS0ANXSG is its advanced energy efficiency. This appliance utilizes state-of-the-art technologies to consume less power while delivering exceptional performance. With energy-saving modes and automatic adjustments based on usage patterns, it not only minimizes electricity costs but also reduces environmental impact, aligning with sustainable living practices.

The appliance incorporates SmartThings technology, allowing users to control and monitor it remotely through their smartphones. This integration provides unparalleled convenience, enabling users to adjust settings, receive alerts, and even troubleshoot issues while away from home. The seamless connectivity enhances user experience, making it easier than ever to fit modern appliances into a busy lifestyle.

Design-wise, the AP0AS0ANXSG boasts a sleek and modern aesthetic that complements any home décor. Its ergonomic features include easy-to-use controls and a user-friendly interface that simplifies operation. Additionally, its compact size makes it suitable for various living spaces without compromising on performance or capacity.

In terms of performance, the AP0AS0ANXSG excels in delivering high-quality results. Whether it's cooking, cleaning, or other functions, this appliance is engineered to perform efficiently and effectively. The latest technology ensures that tasks are completed quickly, saving users valuable time.

Safety features in the AP0AS0ANXSG are also noteworthy. With multiple safety mechanisms, users can have peace of mind while using the appliance. These features are essential in households with children or pets, enhancing overall safety without sacrificing convenience or functionality.

Moreover, the AP0AS0ANXSG is designed to last, utilizing durable materials and components that withstand regular use. Samsung's reputation for reliability is evident in the construction of this appliance, contributing to its longevity and sustained performance over time.

In summary, the Samsung AP0AS0ANXSG is an exemplary appliance that incorporates energy efficiency, smart technology, aesthetic appeal, safety features, and robust performance. It represents a blend of style and functionality, making it a worthwhile investment for consumers seeking advanced solutions in their homes. With its innovative approach, Samsung continues to lead the industry, offering products that align with contemporary needs and preferences.