Weil-McLain PLUS-E017-A/1206 manual B1 Install system water piping space heating

Page 27

Manual • Installation • Start-Up • Usage

• Maintenance • Parts

 

 

 

 

 

 

 

 

 

gas

 

 

 

 

 

 

 

 

 

 

B1 Install system water piping (space heating) (continued)

 

Zoning with circulators

 

 

 

 

 

 

 

 

 

 

Figure 13 Circulator zoning plus optional water

 

 

 

 

1. Connect boiler to system as shown in Figure 13

 

 

 

heater piping

 

 

when circulator zoning. The boiler circulator can-

 

 

 

 

 

 

 

 

 

 

 

not be used for a zone. It must supply only the boiler

 

 

 

 

 

 

 

 

 

 

 

loop.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

2. Install a separate circulator for each zone.

3. Connect water heater (domestic hot water) pip- ing to indirect storage water heater as shown in Section A of this manual.

The PhD Control Module turns off space heating during water heater heat- ing. The boiler circulator will turn off, preventing hot water from circulating to the system. The flow/check valve shown on the boiler outlet piping prevents grav- ity circulation in the boiler loop during water heater heating.

NOTE 1: To ensure adequate flow rate through the boiler, use the following pipe size on all boiler loop piping (connecting boiler to and from the primary/secondary connection, item 21):

-80 or -105 – 1” or larger.

-155 or -230 – 1¼” or larger. -310 – 1½” or larger.

Use at least the minimum piping size above and pipe the boiler using only pri- mary/secondary piping as shown. Failure to follow these guidelines could result in system problems.

Legend

Figure 13

1 boiler

2PLUS-Line indirect water heater

3Boiler relief valve (see boiler manual for piping details)

4Boiler relief valve discharge piping (see boiler manual for details)

5Water heater circulator (see page 7 for suggested sizing)

6Isolation valves

7System circulator

8Diaphragm (or bladder) type expansion tank (see page 3 for piping of closed-type expansion tank, if used)

9Air separator [with automatic air vent only on systems using diaphragm (or bladder) type expansion tank]

10Flow/check valves (with weighted seats to prevent gravity circulation)

11Purge/drain valves

12Boiler circulator

14Zone circulators, typical

20Make-up water supply

21Primary/secondary connection

Part Number PLUS-E017-A/1206

27

Page 26 Page 28
Image 27
Page 26 Page 28
Contents Plus Line Hazard definitions Read this page firstContents Zoning with pumps Gold Plus 30/40/60/80 or Plus 40/60/80 Plus 100/110/119 Multiple water heater applications Plus 100/110/119 see Figure A1 Pre-installationCodes Gold Plus 30/40/60/80 or Plus 40/60/80 see FigureRestrictions Code restrictions National Standard Plumbing CodeUniform Plumbing Code Temperature & pressure T & P relief valve Water heater pipingAir vent Drain valve A2 Water heater piping Gold Plus 30/40/60/80 Or Plus 40/60/80 Option Plus 100/110/119 Option A2 Water heater piping General piping information Thermal expansion Water hammerBoiler water Water heater wiring Filling the inner domestic water tank A4 Water heater start-upA4 Water heater start-up  General notes A5 Adjusting water heater temperatureA5 Adjusting water heater temperature  Setting the thermostatGold Plus 30/40/60/80 Plus 100/110/119 Plus 40/60/80 Maintenance schedule annual service technician A6 Water heater maintenanceA6 Water heater maintenance  Filling DrainingDraining inner domestic water tank A7 Recirculation and heat tracing · Recirculation· Self-regulating heat tracing Components Gas-fired boiler applications B1. Install system water pipingSizing space heat system piping System water piping methodsExpansion tank and make-up water Boiler circulatorZoning with zone valves Install system water piping space heatingZoning with circulators B1 Install system water piping space heatingInstall boiler-to-water heater piping Combined space heating/water heating applicationsDedicated water heating-only applications For boilers other than Ultra Gas, see page 67 for ratings Wiring water heater circulator B3 Field wiring Gas boilers onlyInstallation must comply with Wiring boiler circulatorWater heater thermostat Wiring a system circulatorRouting line voltage wiring Outdoor temperature sensorLow voltage field wiring connections Water heater operation Follow boiler manual Water heater operation setupB4 Start-up Gas boilers only Set space heating operationVerify water heater operation Operating informationReplace jacket front door Boiler-side piping except Gas Boiler-side piping except Gas  Wiring optionsPrimary/secondary piping 60 Pump relays and 3-way priority valve and priority relay 58 or , page 59 Priority using 2-way valve Tions Applications Multiple water heaters This diagram Special considerations Connecting water heater to steam boilerSteam boiler application Boiler-side wiring & controls except Gas Boiler Models Boiler-side wiring & controls except Gas Circulators Zone ValvesSystem piping Typical wiringPump zones Primary/secondary piping sys- temsBoiler-side wiring & controls except Gas  Zoning with pumps Using pump relays No domestic priority 39 using 2-way water heater zone valve and no priority valve Zoning with 4-wire zone Valves No domestic priority Zoning with 3-wire zone valves No domestic priority Plus 40/60/80 Boiler-side wiring & controls except Gas  39 using 2-way Water heater zone valve and no priority valve Boiler-side wiring & controls except Gas  Room Thermostat Pump relays Replacement parts Series 3 only Gold Plus 30/40/60/80 or Plus 40/60/80 Replacement parts Weil-McLain Part Description Size ManufacturerPlus 100/110/119 Replacement parts Plus 100/110/119 Series Dimensions PLUS-Line indirect water heaters, Series Water heater dimensionsMBH Water heater performance ratingsWeil-McLain Limited Warranties

PLUS-E017-A/1206 specifications

The Weil-McLain PLUS-E017-A/1206 is a high-performance heating boiler that reflects the brand's commitment to quality engineering and advanced technology. This model is renowned for its efficiency and reliability, making it a preferred choice for both residential and commercial heating applications.

One of the standout features of the PLUS-E017-A/1206 is its exceptional efficiency rating. The boiler employs advanced condensing technology, which allows it to utilize the latent heat in exhaust gases. This means it can achieve efficiency levels of over 90%, significantly reducing energy consumption and lowering utility bills. The unit also complies with stringent regulatory standards, making it an environmentally friendly heating solution.

The PLUS-E017-A/1206's compact design is another significant characteristic, allowing for easy installation even in limited spaces. It is built with durable materials that enhance its longevity and efficiency. The sleek appearance of the unit also makes it suitable for various settings, maintaining aesthetic appeal while delivering powerful heating performance.

This boiler is equipped with advanced controls and a user-friendly interface, offering precise temperature management and efficient operation. The control panel showcases a digital display, enabling easy monitoring of system performance. Additionally, it allows for integration with smart home systems, providing users with enhanced control over their heating systems remotely.

Safety features are paramount in the PLUS-E017-A/1206. It includes multiple safety mechanisms designed to prevent overheating and pressure issues, ensuring worry-free operation. These elements, combined with Weil-McLain’s reputation for durable construction, contribute to the boiler’s overall reliability.

The PLUS-E017-A/1206 is designed with ease of maintenance in mind. It features accessible components that can be easily serviced, minimizing downtime and reducing maintenance costs. With Weil-McLain’s extensive network of support, users can rely on expert assistance when needed.

Overall, the Weil-McLain PLUS-E017-A/1206 is a robust heating solution that combines efficiency, safety, and advanced technology. Its range of features makes it an excellent choice for those seeking a dependable boiler that delivers consistent performance and energy savings. Whether for a home or business, the PLUS-E017-A/1206 represents a smart investment in heating technology.
Top Page Image Contents