BUILDER'S CHOICE SERIES INSTALLATION INSTRUCTIONS
G. ASSEMBLING VENT SECTIONS
1.ATTACHING THE VENTING TO THE APPLIANCE
To attach the first VP section to the appliance collars, simply slide the flared end of the inner vent of the VP section over the inner collar on the appliance. At the same time, insert the outer vent into the outer collar on the appliance. Push the vent section into the appliance collar until all the lances have snapped in place. Tug slightly on the vent to confirm it has completely locked into place.
2.ASSEMBLING VENT SECTIONS
a.Start the flared inner flue of section “A” over the inner flue of section “B”.
b.Insert the outer flue of section “A” into the outer flue of section “B”. See Figure 19. Once both inner and outer flues are started, press section “A” into section “B” firmly until all lances have snapped into place. Tug slightly on section “A” to confirm it has completely locked into place. See Figure 20.
Note: Squeezing the pipe slightly to fit may be necessary.
Note: Make sure that the seams are not per- fectly aligned to prevent unintentional discon- nection.
Figure 19
Figure 20
3.ASSEMBLING MINIMUM INSTALLATIONS (MI) SECTIONS
MI sections are
21.They can then be attached by first connecting the expanded end of the MI inner vent with the inner vent from the adjacent vent section and securing with three screws. The expanded portion of the MI inner vent must overlap completely with the untreated end of the adjacent vent section. The outer vent can then be inserted into the adjacent outer vent expanded end and attached to the next vent section with three screws.
The other end of the MI vent section can then be | Figure 21 | |
attached by fitting a snap lock section to it and snapping | ||
| ||
it together as normal. |
|
13 | 33606 Rev D |