BUILDER'S CHOICE SERIES INSTALLATION INSTRUCTIONS
4. CLEANING THE GLASS
See Figure 34. Never operate this appliance without the glass properly secured in place or if the glass is broken or chipped.
In the event of glass breakage, carefully remove the glass frame. This will allow the removal of all glass fragments and sheet metal edge protection strips. Vacuum all remaining glass pieces with a shop vac. DO NOT VACUUM IF PIECES ARE HOT! Replace glass only with a Heatilator glass panel assembly through your local distributor. Never use substitute material. Only fully tempered soda lime safety glass or ceramic glass may be used on this appliance.
1.Lift and pull out upper grille and control access panel.
2.Lift and pull out the bottom of the screen, then pull down out of top corner retainers.
3.Pull and release the two Quick Access Latches™ using handle provided and stored in valve compart- ment.
4.Angle top of glass out and remove from the lower re- tainer.
5.Set the glass safely on a nonabrasive surface. Clean using a mild, nonabrasive cleaning solution (i.e. Brasso).
Figure 34
Glass Cleaning
Quick Access Latch™
6.To replace the glass, ensure the glass bottom is set com- pletely down in the bottom re- tainer and replace the two Quick Access Latches™ to the “secure” position.
7.To replace the screen, place the top of the screen in the two corner catches. Raise the screen until it clears the bottom retainer, then lower into position.
8.Replace Quick Access Latch™ handle in its clips on the lower corner behind the grille.
9.Replace the upper grille and control access panel.
Safety Note:
Handle glass with care to avoid striking, scratching or slam- ming shut. Never clean glass when hot. Keep children and pets a safe distance away.
5. LOG REMOVAL/REPLACEMENT
If removal of the logs becomes necessary, remove the two screws at each side of the front log. Grasp the front log. Pull the log toward the front and up, off the burner. See Figure 35.
To replace the logs, grasp the front log. Lower the log set so that the back log rests on the shelf in the back of the appliance and the two tabs behind the back log are inserted into the slots in the back of the firebox. Replace the two screws removed earlier at each end of the front log.
Figure 35 - Log Removal
33606 Rev D | 22 |