Heatiator BCDV36 manual Lighting Instructions, Do not light by hand

Page 19

BUILDER'S CHOICE SERIES INSTALLATION INSTRUCTIONS

K. LIGHTING INSTRUCTIONS

FOR YOUR SAFETY READ BEFORE LIGHTING

WARNING!

If you do not follow these instructions exactly, a fire or explosion may result causing property damage, per- sonal injury or loss of life.

A. This appliance has a pilot which must be lighted by hand. When lighting the pilot, follow these instructions exactly.

B.BEFORE LIGHTING smell all around the appliance area for gas. Be sure to smell next to the floor because some gas is heavier than air and will settle on the floor.

WHAT TO DO IF YOU SMELL GAS

Do not try to light any appliance.

Do not touch any electric switch; do not use any phone in your building.

Immediately call your gas supplier from a neighbor’s phone. Follow the supplier’s instructions.

If you cannot reach your gas supplier, call the fire department.

C.Use only your hand to push in or turn knob. Never use tools. If the knob will not push in or turn by hand, don’t try to repair it; call a qualified service technician. Force or attempted repair may result in a fire or explosion.

D.Do not use this appliance if any part has been under water. Immediately call a qualified service technician to inspect the appliance and to replace any part of the control system and any gas control which as been under water.

LIGHTING INSTRUCTIONS

STOP! Read the safety information above on this label!

1.Turn off all wall switches to the appliance or remote.

2.Open the control access panel.

3Turn gas line to “CLOSED”. Wait 5 minutes to clear out any gas. Then smell for gas, including near the floor. If you smell gas, STOP! Follow “B” in the safety information above on this label. If you don’t smell gas, go to the next step.

4Turn gas line valve to “OPEN”.

5Turn pilot knob clockwise to “OFF” (knob may have to be depressed to pass the “PILOT” position).

6Locate pilot assembly inside appliance.

7Locate red ignitor button in the bottom of the appli- ance.

8Turn pilot knob to “PILOT” and push in.

9.Continue to hold in pilot knob and push the red igni- tor button 12-15 times until small blue pilot flame appears.

10.Continue to hold in pilot knob for approximately one minute. Pilot should remain lit. If pilot goes out, wait 5 minutes and repeat Steps 4-9.

11Release and turn the knob counterclockwise to “ON”. Turn the wall switch to “ON” to light the main burner.

Do not light by hand!

12.If the appliance will not operate, follow the instruc- tions “To Turn Off Gas To Appliance” and call your service technician or gas supplier.

TO TURN OFF THE GAS TO THE APPLIANCE

1.Turn off the wall switch or set thermostat to lowest setting.

2.Close the control access panel.

3.Turn gas line to CLOSED position. Do not force.

4.Close control access panel.

01-03

19

33606 Rev D

Image 19
Contents Installation & Operating Instructions Please retain this manual for future reference Local Codes Appliance SpecificationsGlass CERTIFICATIONS/SPECIFICATIONS S. and Canada CertificationBuilders Choice Series Installation Instructions Builders Choice Nomenclature NomenclatureCatalog # Description Appliance Locations and Space Requirements Location and ClearancesClearances Wear gloves and safety glasses for protection Setting the ApplianceFraming Termination Installing the Interior Wall ShieldVenting Horizontal TerminationTwo Elbows Three Elbows One Elbow Horizontal No ElbowsRear Vented Appliances 45 Elbow One 45 Elbow Two ElbowsTermination Cap Locations Dimension DescriptionsVent Support Vertical TerminationClearances Vent Clearances Vent LengthsInstalling the Firestop Spacer Roof Pitch Min. Ft Firestop Spacer/Chimney InstallationChimney Height Chase/Termination Installation Assembling Vent Sections Assembling Minimum Installations MI SectionsAssembling Vent Sections Attaching the Venting to the ApplianceDisassembling Vent Sections only if Necessary Assembling Slip SectionsGAS Conversions UtilitiesGAS Line Connection GAS PressureStanding Pilot Ignition Wiring Diagram WiringJunction BOX Installation and Wiring Wall SwitchFinishing Placing the Vermiculite and Lava Rock Glass and Screen ReplacementAppliance Preparation LOG SETDo not light by hand Lighting InstructionsPrior to Operation Seasonal ChecklistStanding Pilot Operation Maintenance Instructions START-UP IssuesFuel Conversion LOG REMOVAL/REPLACEMENT Cleaning the GlassGlass Cleaning Fan Kit Optional ComponentsBCDV36 Gas Log Assembly Replacement PartsHOMEOWNER’S Notes HOMEOWNER’S Notes Index Conditions, Exclusions, & Limitations of Liability Limited Lifetime WarrantyYear Limited Warranty How to Obtain Service