Heatiator BCDV36 Framing, Setting the Appliance, Wear gloves and safety glasses for protection

Page 7

BUILDER'S CHOICE SERIES INSTALLATION INSTRUCTIONS

D. FRAMING

Figure 3 shows a typical framing of this appliance using combustible materials. Figure 4 shows the mantel heights for mantel projections. All required clearances to combustibles must be adhered to.

CAUTION:

Wear gloves and safety glasses for protection.

Figure 4 - Mantel Height

* from base of appliance

Figure 3 - Framing

CAUTION:

Provide adequate clearances around the air open- ings into the combustion chamber and adequate ac- cessibility clearances for servicing and proper op- eration.

WARNING!

To prevent contact with sagging or loose insulation, the appliance must not be installed against vapor barriers or exposed insulation. Localized overheating could occur and a fire could result.

E. SETTING THE APPLIANCE

This appliance may be placed on a smooth combustible or noncombustible continuous, flat surface. When the appliance is installed directly on carpeting, tile or other combustible material other than wood flooring, the appliance shall be installed on a metal or wood panel extending the full width and depth of the appliance. Slide the appliance into position and level the appliance from side-to-side and front-to-back. Shim as necessary.

Secure the appliance by bending out the nailing flanges on each side of the appliance and nail to framing. The nailing flanges have been positioned 5/8 inch back from the front of the appliance to allow the addition of drywall.

01-03

7

33606 Rev D

Image 7
Contents Installation & Operating Instructions Please retain this manual for future reference Local Codes Appliance SpecificationsGlass CERTIFICATIONS/SPECIFICATIONS S. and Canada CertificationBuilders Choice Series Installation Instructions Builders Choice Nomenclature NomenclatureCatalog # Description Appliance Locations and Space Requirements Location and ClearancesClearances Wear gloves and safety glasses for protection Setting the ApplianceFraming Termination Installing the Interior Wall ShieldVenting Horizontal TerminationTwo Elbows Three Elbows One Elbow Horizontal No ElbowsRear Vented Appliances 45 Elbow One 45 Elbow Two ElbowsTermination Cap Locations Dimension DescriptionsVent Support Vertical TerminationClearances Vent Clearances Vent LengthsInstalling the Firestop Spacer Roof Pitch Min. Ft Firestop Spacer/Chimney InstallationChimney Height Chase/Termination Installation Assembling Vent Sections Assembling Minimum Installations MI SectionsAssembling Vent Sections Attaching the Venting to the ApplianceDisassembling Vent Sections only if Necessary Assembling Slip SectionsGAS Conversions UtilitiesGAS Line Connection GAS PressureStanding Pilot Ignition Wiring Diagram WiringJunction BOX Installation and Wiring Wall SwitchFinishing Placing the Vermiculite and Lava Rock Glass and Screen ReplacementAppliance Preparation LOG SETDo not light by hand Lighting InstructionsPrior to Operation Seasonal ChecklistStanding Pilot Operation Maintenance Instructions START-UP IssuesFuel Conversion LOG REMOVAL/REPLACEMENT Cleaning the GlassGlass Cleaning Fan Kit Optional ComponentsBCDV36 Gas Log Assembly Replacement PartsHOMEOWNER’S Notes HOMEOWNER’S Notes Index Conditions, Exclusions, & Limitations of Liability Limited Lifetime WarrantyYear Limited Warranty How to Obtain Service