Heatiator C40 Listing and Code Approvals, Appliance Certification, Manufactured Home Approved

1 Listing and Code Approvals

A. Appliance Certification

This fireplace system has been tested and listed in accordance with UL127 and ULC-S610-M87 and (UM) 84-HUD standards, and has been listed by OMNI Test Laboratory Inc., for installation and operation in the United States and Canada as described in this manual. This fireplace has been tested and listed for use with the SL- 300 Series chimney (with the CAK4A Air Kit) and fireplace components listed in Section 12.

Check with your local building code agency before you begin your installation to ensure compliance with local codes, including the need for permits and follow-up inspections. Be sure local building codes do not supersede UL specifica- tions and always obtain a building permit so that insurance protection benefits cannot be unexpectedly cancelled.

Heatilator is a registered trademark of Hearth & Home Technologies Inc.

Model:	Constitution EPA Certified
	Woodburning Fireplace
Laboratory:	OMNI Test Laboratories, Inc.
Report No:	061-S-50-2
Type:	Wood Fireplace
Standard:	UL127 and ULC-S610-M87 and
	(UM) 84-HUD, Manufactured Home
	Approved.

Warning! Risk of Fire! Improper installation of wood in- serts may cause fireplace or chimney system to overheat.

B. Manufactured Home Approved

This appliance is approved for manufactured home instal- lations when not installed in a sleeping room and when an outside combustion air inlet is provided. THE STRUC-

TURAL INTEGRITY OF THE MANUFACTURED HOME FLOOR, CEILING, AND WALLS MUST BE MAINTAINED. The fireplace must be properly grounded to the frame of the manufactured home. Outside Air must be installed in a

manufactured home installation.

An outside air termination cap is supplied with your Constitution Fireplace for installation in a manufactured home. If you use an alternative material it must be designed to prevent material from dropping into the area beneath the manufactured home, and to prevent rodents from entering from the outside.

1.An outside air inlet must be provided for combustion and must remain clear of leaves, debris, ice and/or snow. It must be unrestricted while unit is in use to prevent room air starvation which can cause smoke spillage and an inability to maintain a fire. Smoke spillage can also set off smoke alarms.

2.The fireplace is to be secured to the manufactured home structure. Use same holes that attached the fireplace to the pallet to secure it to the floor using 1/4 in. x 2 in. (6 mm x 51 mm) lag bolts or equivalent.

3.Unit must be grounded with #8 solid copper grounding wire or equivalent and terminated at each end with N.E.C. approved grounding device.

4.Refer to Minimum Clearances to Combustibles on pages

36-37 and chimney components on pages 64-65

5.Floor protections requirements on pages 54-56 must be followed precisely.

6.Use silicone to create an effective vapor barrier at the location where the chimney or other component penetrates to the exterior of the structure.

7.If unit burns poorly while an exhaust fan is on in home, (i.e., range hood), increase combustion air.

NOTICE: Top sections of chimney must be removable to allow maximum clearance of 13.5 ft (411 cm) from ground level for transportation purposes.

Warning! Risk of Fire or Asphyxiation! DO NOT install in sleeping room

Caution! Maintain structural intergrity of manufactured home:

•Floor, wall, ceiling and /or roof.

•Any supporting materal that would affect the structural integrity.

•Do NOT cut through:

Floor joist, wall, studs or ceiling trusses.

Warning! Risk of Fire!

For use with solid wood fuel only. Other fuels may overfire and generate poisonous gases (i.e. carbon monoxide).

Page 6 Heatilator • Constitution EPA Fireplace • 480-1091D 4/20/11