OWNER’S MANUAL
PRODUCT
IDENTIFICATION
Piezo Ignitor Button
Control Knob
Grill
Guard
Burners
Heater
FrontCabinet
Panel
Unusually Tight Construction
The air that leaks around doors and win- dows may provide enough fresh air for combustion and ventilation. However, in buildings of unusually tight construction, you must provide additional fresh air.
Unusually tight construction is de- fined as construction where:
a.walls and ceilings exposed to the outside atmosphere have a con- tinuous water vapor retarder with a rating of one perm
b.weather stripping has been added on openable windows and doors and
c.caulking or sealants are applied to areas such as joints around win- dow and door frames, between sole plates and floors, between wall- ceiling joints, between wall panels, at penetrations for plumbing, elec- trical, and gas lines, and at other openings.
Figure 1 -
If your home meets all of the three criteria above, you must provide additional fresh air. See Ventilation Air From Outdoors,
AIR FOR COMBUSTION AND VENTILATION
WARNING: This heater shall not be installed in a confined space unless provisions are pro- vided for adequate combustion and ventilation air. Read the fol- lowing instructions to insure proper fresh air for this and other
Today’s homes are built more energy effi- cient than ever. New materials, increased insulation, and new construction methods help reduce heat loss in homes. Home own- ers weather strip and caulk around windows and doors to keep the cold air out and the warm air in. During heating months, home owners want their homes as airtight as pos- sible.
While it is good to make your home energy efficient, your home needs to breathe. Fresh
air must enter your home. All
Exhaust fans, fireplaces, clothes dryers, and fuel burning appliances draw air from the house to operate. You must provide ad- equate fresh air for these appliances. This will insure proper venting of vented fuel- burning appliances.
PROVIDING ADEQUATE
VENTILATION
The following is excerpts from National Fuel Gas Code. NFPA 54/ANSI Z223.1, Section 5.3, Air for Combustion and Venti- lation.
All spaces in homes fall into one of the three following ventilation classifications:
1.Unusually Tight Construction; 2. Uncon- fined Space; 3. Confined Space.
The information on pages 3 through 5 will help you classify your space and provide adequate ventilation.
page 5.
If your home does not meet all of the three criteria above, proceed to page 4.
Confined and Unconfined Space
The National Fuel Gas Code (ANSIZ2123.1, 1992 Section 5.3) defines a confined space as a space whose volume is less than 50 cubic feet per 1,000 Btu per hour (4.8 m3 per kw) of the aggregate input rating of all appliances installed in that space and an unconfined space as a space whose volume is not less than 50 cubic feet per 1,000 Btu per hour (4.8 m3 per kw) of the aggregate input rating of all appliances installed in that space. Rooms communicating directly with the space in which the appliances are in- stalled*, through openings not furnished with doors, are considered a part of the unconfined space.
*Adjoining rooms are communicating only if there are doorless passageways or ventila- tion grills between them.
Continued
103548 | 3 |