Desa CGP11A installation manual Installing Two Mounting Screws, Folding Anchor

Page 11

INSTALLING

Installing Two Mounting Screws

Note: Wall anchors and mounting screws are in hardware package. The hardware

TO WALL

package is provided with heater.

Continued

Attaching to wall stud method

 

 

For attaching mounting screw to wall stud

 

1.

Drill hole at marked location using 9/64" drill bit.

 

2.

Insert mounting screw into wall stud.

 

3.

Tighten screw until 1/16" space (thickness of penny) is between screwhead and

 

 

wall.

Attaching to wall anchor method

Follow instructions below to attach mounting screws to hollow walls (wall areas between studs) or solid walls (concrete or masonry).

1.Drill holes at marked locations using 5/16" drill bit. For solid walls (concrete or masonry), drill at least 1 1/4" deep.

2.Fold wall anchor (see Figure 6).

Figure 6 - Folding Anchor

3.Insert wall anchor (wings first) into hole. Tap anchor flush to wall.

4.For thin walls (1/2" or less), insert red key into wall anchor. Push red key to “pop” open anchor wings (see Figure 7). IMPORTANT: Do not hammer key! For thick walls (over 1/2" thick) or solid walls, do not pop open wings.

Thin Walls

(1/4" to 1/2" thick)

Figure 7 - Popping Open Anchor Wings For Thin Walls

5.Tighten two screws until 1/16" space (thickness of penny) is between screwheads and wall (see Figure 8).

Thin or Thick Wall (thick wall shown)

1/16" Space

Solid Wall

ANCHOR

Figure 8 - Tightening Anchors

Continued 11

100846

Image 11
Contents What to do if YOU Smell GAS OWNER’S Operation and Installation ManualContents Safety Information Unpacking Safety DeviceProduct Local CodesProducing Adequate Ventilation Fresh AIR ForCombustion VentilationDetermining if You Have a Confined or Unconfined Space Fresh AIRDetermining FRESH-AIR Flow for Heater Location Ventilation Air From Inside Building Fresh AIR for Combustion and VentilationVentilation AIR Ventilation Air From Outdoors Ventilation AIRLocating Heater Installing To WallInstallation Items Check GAS TypeMarking Screw Locations Installing Heater to WallFolding Anchor Installing Two Mounting ScrewsPlacing Heater On Mounting Screws Follow all local codes Connecting To GASQualified service person must connect heater to gas supply SupplyServicing. Correct all leaks at once Pressure Testing GAS Supply Piping SystemChecking GAS ConnectionsChecking Pressure Testing Heater GAS ConnectionsOperating Heater For Your Safety Read Before LightingPilot To Select Heating Level Pilot Flame Pattern HeaterInspecting BurnerBurner Flame Pattern Inspecting BurnerCabinet Trouble ShootingODS/PILOT and Burner Orifice TROUBLE- Shooting See CleaningMaintenance, Top Technical ServiceIng statement at Parts Not Under Warranty ServiceReplacement Parts Parts Under WarrantyValve GA5010 Service Publications AccessoryParts Centrals Illustrated Parts Breakdown Parts ListKeep this Warranty Warranty Information