Desa CGP11A Installing To Wall, Check GAS Type, Installation Items, Locating Heater

Page 9

INSTALLING

NOTICE

TO WALL

A qualified service person must install heater. Follow all local codes.

 

 

 

CHECK GAS TYPE

 

Use only propane gas. If your gas supply is not propane, do not install heater. Call

 

dealer where you bought heater for proper type heater.

INSTALLATION ITEMS

Before installing heater, make sure you have the items below:

• external regulator (supplied by

• manual shutoff valve *

• sediment trap

 

installer, see page 13)

ground joint union

tee joint

piping (check local codes)

test gauge connection *

pipe wrench

sealant (resistant to propane gas)

 

(see Figure 13, page 14)

 

 

*An A.G.A. design-certified manual shutoff valve with 1/8" NPT tap is an acceptable alternative to test gauge connection. The optional A.G.A. design-certified manual shutoff valve can be purchased from your dealer. See Accessory, page 26.

LOCATING HEATER

This heater is designed to be mounted on a wall.

WARNING

Maintain the minimum clearances shown in Figure 4 (page 10). If you can, provide greater clearances from floor, ceiling, and joining wall.

WARNING

Never install the heater

in a bedroom or bathroom

in a recreational vehicle

where curtains, furniture, clothing, or other flammable objects are less than 36 inches from the front, top, or sides of the heater

as a fireplace insert

in high traffic areas

in windy or drafty areas

CAUTION

This heater creates warm air currents. These currents move heat to wall surfaces next to heater. Installing heater next to vinyl or cloth wall coverings or operating heater where impurities in the air (such as tobacco smoke) exist, may discolor walls.

IMPORTANT: Vent-free heaters add moisture to the air. Although this is beneficial, in- stalling heater in rooms without enough ventilation air may cause mildew to form from too much moisture. See Fresh Air for Combustion and Ventilation, pages 5 through 8.

CAUTION

If you install the heater in a home garage

heater pilot and burner must be at least 18 inches above floor

locate heater where moving vehicle will not hit it

Continued

9

 

100846

Image 9
Contents What to do if YOU Smell GAS OWNER’S Operation and Installation ManualContents Safety Information Product Safety DeviceLocal Codes UnpackingCombustion Fresh AIR ForVentilation Producing Adequate VentilationFresh AIR Determining FRESH-AIR Flow for Heater LocationDetermining if You Have a Confined or Unconfined Space Fresh AIR for Combustion and Ventilation Ventilation AIRVentilation Air From Inside Building Ventilation Air From Outdoors Ventilation AIRInstallation Items Installing To WallCheck GAS Type Locating HeaterMarking Screw Locations Installing Heater to WallFolding Anchor Installing Two Mounting ScrewsPlacing Heater On Mounting Screws Qualified service person must connect heater to gas supply Connecting To GASSupply Follow all local codesChecking GAS Pressure Testing GAS Supply Piping SystemConnections Servicing. Correct all leaks at onceChecking Pressure Testing Heater GAS ConnectionsOperating Heater For Your Safety Read Before LightingPilot To Select Heating Level Inspecting HeaterBurner Pilot Flame PatternBurner Flame Pattern Inspecting BurnerTrouble Shooting ODS/PILOT and Burner OrificeCabinet TROUBLE- Shooting See CleaningMaintenance, Technical Service Ing statement atTop Replacement Parts ServiceParts Under Warranty Parts Not Under WarrantyService Publications Accessory Parts CentralsValve GA5010 Illustrated Parts Breakdown Parts ListKeep this Warranty Warranty Information