CLEANING AND MAINTENANCE
TROUBLE-
SHOOTING
Note: All troubleshooting items are listed in order of operation.
WARNING
WARNING ICON | G 001 |
Turn off heater and let cool before cleaning.
CAUTION
WARNING ICON | G 001 |
You must keep control areas, burner, and circulating air passage- ways of heater clean. Inspect these areas of heater before each use. Have heater inspected yearly by a qualified service person. Heater may need more frequent cleaning due to excessive lint from carpeting, bedding material, etc.
ODS/PILOT AND BURNER
• Use a vacuum cleaner or small, soft bristled brush to clean.
LOGS
• Replace log(s) if broken or chipped
WARNING
WARNING ICON | G 001 |
Turn off heater and let cool before servicing. Only a qualified service person should service and repair heater.
CAUTION
WARNING ICON | G 001 |
Never use a wire, needle, or similar object to clean ODS/pilot. This can damage ODS/pilot unit.
OBSERVED | POSSIBLE |
|
| |
PROBLEM | CAUSE | REMEDY | ||
|
|
|
|
|
When ignitor button | 1. | Ignitor electrode not con- | 1. | Reconnect ignitor cable |
is pressed, there is no |
| nected to ignitor cable |
|
|
spark at ODS/pilot | 2. | Ignitor cable pinched or | 2. | Free ignitor cable if |
|
| wet |
| pinched by any metal or |
|
|
|
| tubing. Keep ignitor |
|
|
|
| cable dry |
| 3. | Piezo ignitor nut is loose | 3. | Tighten nut holding |
|
|
|
| piezo ignitor to base |
|
|
|
| panel of log set. Nut is |
|
|
|
| located behind base |
|
|
|
| panel. |
| 4. | Broken ignitor cable | 4. | Replace ignitor cable |
| 5. | Bad piezo ignitor | 5. | Replace piezo ignitor |
| 6. | Ignitor electrode posi- | 6. | Replace ignitor |
|
| tioned wrong |
|
|
| 7. | Ignitor electrode broken | 7. | Replace ignitor |
Continued
104024
21