Connecting to GAS Supply, Installation Items Needed

INSTALLING

Continued

8.Set one-piece log on heater base as shown in Figure 15. Make sure middle section at bottom of log is seated into "U" shaped cutout in center of heater base. Log will fit securely on base. IMPORTANT: Make sure log does not cover any burner ports and does not touch the stove cavity (see Figure 16).

	One-Piece
	Log Set
Middle Section at
Bottom of Log Set	Burner
	Burner
	"U" Shaped
	Cutout in Chassis
	Heater Base

Figure 15 - Installing One-Piece Stove Log Set

Burner Porting Areas (double slotted rectangular openings

Safety Pilot

Location

One-Piece Log Set

Figure 16 - Top View of One-Piece Log Set on Gas Log Heater

9.Fasten back panel to stove with six (6) M6 x 1.20mm bolts and washers. Make sure product identification label is located on the outside lower left-hand corner.

10.Place freestanding stove in desired position in room. Be sure to maintain clearances to combustibles as outlined on page 8.

CONNECTING TO GAS SUPPLY

NOTICE

A qualified service person must connect heater to gas supply. Follow all local codes.

Installation Items Needed

Before installing heater, make sure you have the items listed below.

•	piping (check local codes)	•	sediment trap
•	sealant (resistant to LP gas)	•	tee joint
•	manual shutoff valve *	•	pipe wrench
•	test gauge connection *

104024