Desa SVYD18N installation manual For use with this heater

Page 3

 

 

 

 

 

 

 

SAFETY

 

WARNING ICONG 001WARNINGS Continued

 

 

 

WARNING: Any change to this heater or its controls can be dangerous.

 

 

INFORMATION

 

 

 

 

1. This appliance is only for use with the type of gas indicated on the rating plate.

 

 

Continued

 

This appliance is not convertible for use with other gases.

 

 

 

2. If you smell gas

 

 

 

 

 

 

 

 

• shut off gas supply

 

 

 

 

• do not try to light any appliance

 

 

 

 

• do not touch any electrical switch; do not use any phone in your building

 

 

 

 

• immediately call your gas supplier from a neighbor’s phone. Follow the gas

 

 

 

 

supplier’s instructions

 

 

 

 

• if you cannot reach your gas supplier, call the fire department

 

 

 

 

3. This heater shall not be installed in a bedroom or bathroom.

 

 

 

 

4. Never install the heater

 

 

 

 

• in a recreational vehicle

 

 

 

 

• where curtains, furniture, clothing, or other flammable objects are less than

 

 

 

 

the minimum clearances to combustibles (see page 8)

 

 

 

 

• in high traffic areas

 

 

 

 

• in windy or drafty areas

 

 

 

 

5. Do not use this stove as a wood burning fireplace. Use only model SVYD18N

 

 

 

 

vent-free gas log heater.

 

 

 

 

6. Do not add extra logs or ornaments such as pine cones, vermiculite, or rock wool.

 

 

 

 

Using these added items can cause sooting.

 

 

 

 

7. This log heater is designed to be smokeless. If logs ever appear to smoke, turn off

 

 

 

 

heater and call a qualified service person. Note: During initial operation, slight

 

 

 

 

smoking could occur due to log curing and heater burning manufacturing

 

 

 

 

residues.

 

 

 

 

8. Do not allow fans to blow directly into the stove. Avoid any drafts that alter burner

 

 

 

 

flame patterns. Ceiling fans can create drafts that alter burner flame patterns.

 

 

 

 

Altered burner patterns can cause sooting.

 

 

 

 

9. Do not use a blower insert, heat exchanger insert or other accessory not approved

 

 

 

 

for use with this heater.

 

 

 

 

10. This heater needs fresh, outside air ventilation to run properly. This heater has an

 

 

 

 

oxygen depletion sensor (ODS) pilot light safety system. The ODS shuts down

 

 

 

 

the heater if not enough fresh air is available. See Air for Combustion and

 

 

 

 

Ventilation, pages 5 through 7. If heater keeps shutting off, see Troubleshooting,

 

 

 

 

pages 21 through 24.

 

 

 

 

11. Do not run heater

 

 

 

 

• where flammable liquids or vapors are used or stored

 

 

 

 

• under dusty conditions

 

 

 

 

12. Do not use this stove to cook food or burn paper or other objects.

 

 

 

 

13. Never place any objects on the stove.

 

 

 

 

14. Stove becomes very hot when running heater. Keep children and adults away

 

 

 

 

from hot surface to avoid burns or clothing ignition. Heater will remain hot for

 

 

 

 

a time after shutdown. Allow surface to cool before touching.

 

 

 

 

15. Carefully supervise young children when they are in the room with heater.

 

 

 

 

16. Do not use heater if any part has been exposed to or under water. Immediately call

 

 

 

 

a qualified service technician to inspect the room heater and to replace any part

 

 

 

 

of the control system and any gas control which has been under water.

 

 

 

 

17. Do not operate heater if any log is broken. Do not operate heater if a log is chipped

 

 

 

 

(dime-sized or larger).

 

 

 

 

18. Turn heater off and let cool before servicing. Only a qualified service person

 

 

 

 

should service and repair heater.

 

 

 

 

19. Operating heater above elevations of 4,500 feet could cause pilot outage.

 

 

 

 

 

 

 

 

 

 

 

3

 

 

 

 

 

 

 

 

 

104024

Image 3
Contents What to do if YOU Smell GAS OWNER’S Operation and Installation ManualContents Safety Information For use with this heater Piezo Ignition System Local Codes Product FeaturesSafety Pilot OperationAIR for VentilationProviding Adequate Ventilation AIR for Combustion and Ventilation Determining AIR Flow for Heater LocationDetermining if You Have a Confined or Unconfined Space Ventilation AIR Installing Check GAS TypeMinimum Wall and Ceiling Clearances see Figure Side View Stove Cavity AssemblyFront View Top ViewLaying Down Stove On Side Attaching Stove Legs Attaching Stove Door Placing Heater Base In Stove Cavity Installing Installing GAS LOG Heater Into StoveInstallation Items Needed Connecting to GAS SupplySide View Back View Gas Connection Checking GAS ConnectionsTest Pressures Equal To or Less Than 1/2 Psig Pressure Testing Heater Gas ConnectionsOperating Heater For Your Safety Read Before LightingHeater Match, see Manual Lighting Procedure onPilot Flame Pattern Operating Heater Inspecting BurnersLogs Cleaning and Maintenance Trouble ShootingTurn off heater and let cool before cleaning ODS/PILOT and BurnerTROUBLE- Shooting Maintenance,Refer to Air for Com Gas leak. See Warning Hints ServiceReplacement TechnicalIllustrated Parts Breakdown Parts List SCIVFC, Scivfb SCIVFG, Scivfr SCIVFC, Scivfb Valve GA5010 Accessory104024 Keep this Warranty Warranty Information