R
Cape Cod Wood Stove
ASSEMBLY
INSTALLATION
1Place the unit in a location near the final installation area and follow the procedures below:
2Open the stove and remove all the parts and articles packed inside. Inspect all the parts and cast iron body for shipping damage. Contact your dealer if any irregularities are noticed.
3Install floor protection if the heater is being placed on a combustible floor. Refer to the section on floor protectors for required materials and sizes on page 10.
4REMOVE ANY LABELS FROM GLASS.
5DO NOT TILT THE UNIT ON THE CAST IRON LEGS: Lift the unit upright and place it into position on the floor protector.
6Ensure that the kaowool insulation is positioned snugly against the rear of the unit, (see page 33, for kaowool blanket location). This eliminates any unburned gases from escaping prior to burning.
REVERSIBLE FLUE COLLAR
The Cape Cod flue collar is reversible for either a top or rear venting installation. The unit is shipped with the flue collar in the top vent position. For rear vent installations adjust the flue collar as follows:
1.Remove 6 Phillips head screws from the vent collar shield, remove shield and discard.
2.Remove bolts from each side of the flue transition (2 total). (Place your free hand in flue opening to locate and retrieve nuts attached to bolts.)
3.Turn vent. Replace bolts and nuts.
FIREBRICK PLACEMENT
Ensure that the firebricks are correctly positioned as referenced by diagram below, and that the firebox does not contain any broken brick prior to operating the unit.
1
2
6.00
54.50
3 | 4 | 6.00 | 2.00 | 6 | 7 | 8 |
| ||||||
|
|
|
|
|
|
4.50
Part Numbers
|
| |
9 | 9.00 |
2.50 10
4.50
9.00
8.25
11 | 12 | 3.75 | 4.50 |
l m | n | o |
|
| p | ||
|
| ||
|
| s |
|
13
15
16
9.00 |
| 1.35 |
|
8.50 |
|
| |
14 |
|
|
|
3.00 |
|
|
|
6.31 | 18 | 7.50 | 9.00 |
|
| ||
|
|
| |
17 |
|
|
|
1.35 | 4.50 |
|
|
|
|
|
k | 11 | 12 | q |
|
| ||
| 13 | 14 |
|
j |
|
| r |
| 15 |
| 18 |
| 16 | 17 |
|
32198A February 15, 2002 | Page 23 |