Monessen Hearth WDV500 manual Remote Control Operation, Remote Transmitter Operations

Page 33

REMOTE CONTROL OPERATION

WDV Series Gas Fireplace

REMOTE TRANSMITTER OPERATIONS

 

General

°F

 

Figure 39

The RFSC Remote Control has two (2) operating modes: Manual and Thermostatic. The control system can be set to a temperature range between 45° F and 90° F. The blower speed, light, rear burner shut down and flame height can be adjusted in either the manual and thermostatic mode.

The transmitter will operate the remote receiver from 12" to a maximum of 30'. NOTE: The distance decreases when the batteries are low.

Initial Startup

Figure 40

▲ON

▲OFF

FAN

AUTO

LIGHT

AUX

AMBIENT

FP2141

 

Figure 39 -

Remote Transmitter

1.After initial power up or when RESET button is pressed, the transmitter is reset. The reset button is located behind the battery door of transmitter.

2.During system reset, all features of the LCD DISPLAY will be visible. After one second, the LCD will be initialized. A typical reset display is shown in Figure 49. Note that the temperature scale is degree F.

3.Press ON button to select between °C and °F display. It will exit setting mode automati- cally after 10 seconds if no key is pressed. The transmitter will send an OFF signal after reset.

4.After reset, the transmitter is operating in manual mode. The room temperature is shown.

Manual Mode

Figure 41

1.Press the ON button once to turn on the appliance with max flame height.

2.Press the OFF button to decrease flame height. The first two (2) presses will decrease flame height to lower level. The third press will turn off the fireplace.

3.If OFF button is held for more than three (3) seconds, the fireplace will be shut off and remembers the last flame height setting. It will also remember light and auxiliary settings. To reset, change setting and hold OFF button for 3 seconds. New setting is now remem- bered.

Thermostatic Mode

Figure 42

1.Press the AUTO button to enter the thermostatic mode.

2.In thermostatic mode, press the ON / ▲ button or OFF / ▼ button to set the desired set temperature.

3.Once the setting is completed, the transmitter will automatically turn on the fireplace when the room temperature is below the set temperature and turn off the fireplace when the room temperature is above the set temperature within 1 degree.

4.There will be a slight delay in the response of the unit (on/off) to a temperature. Room temperature is monitored every three (3) minutes.

5.Press AUTO button to exit the thermostatic mode. The transmitter will be in the manual off mode and the fireplace will be shut off.

NOTE: When thermostat mode is used, the command center ON/OFF buttons will not function, only the master switch will function.

°F

FP2142

Figure 40 -

Typical Reset Display

°F

FP2143

Figure 41 -

Manual Mode

°F

°F

SET

FP2144

Figure 42 - Thermostatic Mode

78D0011

33

Page 32 Page 34
Image 33
Page 32 Page 34
Contents WDV Wideview Direct Vent Gas Fireplace Operating Instructions Signature Command SystemImportant Safety Information InstallerOwner Never connect unit to private non-utility Code ApprovalGas wells. This gas is commonly known As wellhead gasHigh Elevations Product features and code approvalFireplace and Framing Dimensions Fireplace & Framing DimensionsPRE-INSTALLATION Information Fireplace LocationCold Climate Insulation Clearances to combustibles ClearancesMantel clearances Side ViewSecure Fireplace to floor or framing Never install combustible materials overFinishing Material Front face of fireplaceInstallation precautions Venting Installation InformationVoid the warranty Failure to follow these instructions willInstallation planning Vent installationInstalling a vent system in an outside chase For horizontal terminationAir Supply Inlet Area Where Terminals Not Permitted Venting installationFor horizontal termination Inside Corner Detail Minimum distancesHow To Use The Vent Graph Venting installationMaximum Three 3 90 Elbows Per Installation VERTICAL/Horizontal termination configurationsWall Below Grade InstallationsDo not back fill around snorkel Vertical through-the-roof applicationsClearance of at least 4 must be Maintained between the snorkelFlat ceiling installation Venting installation Installation for vertical terminationTermination Heights for Vents Above Flat or Sloped Roofs Flex Vent Installation Flex Vent Installation Installing gas piping to fireplace location Fireplace installationInstallation items needed Check gas typePropane/LP Natural GasElectrical Wiring Do not use open flame to check for gas leaksImproper and dangerous operation Caut NIO AW RNI GN Command Center Wall InstallationSignature command Optional fan blower system Wiring to junction boxOptional Fan/Blower System Blotbldvsc Glass removal & light placement Light InstallationGlass Frame Removal Stone & glass placement Stone & Glass PlacementGlass only Placement What to do if YOU Smell GAS Signature command Operating InstructionsOPERATing Instructions Switch BoxBattery Installation FeaturesSystem CONFIGURATION/SETUP Signature Command System Operation InstructionsKey Combinations for System Settings Function Operation Default SettingCommand Center Operations Command Center FUNCTIONS/OPERATIONSelf Diagnostics Chart Fault LeD IndicationRemote Transmitter Operations Remote Control OperationFlame Height Setting for Thermostatic Mode Speed Blower Control OptionalLevel Light Brightness Control Low Battery Detection Remote Control OperationON/OFF AUX Control Optional Child-Proof ProtectionBurner, Pilot and Control Compartment Cleaning and maintenanceVent SysteM Glass DoorStones Signature Command System TroubleshootingFirebox components and accessories Replacement PartsAccessories / Field Installed Options Description Qty WDV500Replacement Parts LP to Natural Gas Replacement PartsVent components Vent Components for 5 X Current Old Simpson DuraventOr Mhsc Selkirk Box Description Stones WDV Series Gas Fireplace Manufacturer Requirements MassachusettsFive Year Warranty Lifetime WarrantyBasic Warranty If Warranty Service is NeededModel Mhsc

WDV500 specifications

The Monessen Hearth WDV500 is a stylish and efficient direct vent gas fireplace designed to enhance any living space. This fireplace combines modern aesthetics with advanced technology to create a cozy atmosphere while ensuring optimal performance. With its sleek design and versatile installation options, it caters to various home styles, making it an ideal choice for homeowners looking to elevate their ambiance.

One of the standout features of the WDV500 is its direct vent system, which allows for safe and efficient operation. This system utilizes outside air for combustion, ensuring that indoor air quality is maintained. By drawing air from the outside and venting exhaust gases directly outside, the WDV500 minimizes heat loss and maximizes energy efficiency. This makes it an environmentally friendly option, aligning with contemporary sustainability practices.

The Monessen Hearth WDV500 is equipped with a variety of innovative technologies aimed at providing users with ease of use and improved functionality. The adjustable flame control allows homeowners to customize the intensity of the fire to suit their mood or occasion. Additionally, the WDV500 features a high-efficiency burner that generates an impressive heat output, ensuring that rooms are kept warm and inviting even during the coldest months.

In terms of design, the WDV500 offers multiple finish options and accessory features, allowing it to seamlessly blend into any decor. A stunning selection of logs, crystals, or stones enhances the visual appeal of the fireplace, giving it a contemporary touch that complements traditional or modern interiors alike.

Safety is a priority with the Monessen Hearth WDV500, which includes an automatic shut-off feature that engages if the unit experiences overheating, ensuring peace of mind for users. The fireplace's straightforward installation process further emphasizes its user-friendly design, suitable for both new builds and retrofitting into existing spaces.

Overall, the Monessen Hearth WDV500 represents a harmonious blend of technology, safety, and style. Whether for relaxation on chilly evenings or for entertaining guests, this versatile fireplace provides warmth and elegance, making it a perfect addition to any home. Its efficient performance, customizable features, and aesthetic appeal make the WDV500 a popular choice among discerning homeowners.
Top Page Image Contents