13
FACE PLATE, UPPER GRILL, KEYSTONE & DOOR INSTALLATION
1Remove the facing template held in place with the 12 screws shown. Dis- card the screws and template.
2Mount the keystone and upper grill to the face- plate, as shown, using the 4 nuts supplied.
Remove the backing and place logo onto the bottom left corner of the faceplate.
Ensure that the pressure switch actuating arm and air control rod, protrude through the faceplate when in- stalled.
Remember to record your serial # in the manual for future quick reference.
3 Secure the faceplate to the unit, using the 12
screws supplied.
Start all 12 screws, then tighten evenly.
Right Door Handle
4(operating)
-Insert the door rod through the round hole of the latch ensuring the flat edge of the “D” shaped hole points towards the
hinges.
-Slide the end of the door rod through the bushing at the top of the door as shown.
-Insert the handle shaft through the door and the latch.
See Note #1
- Feed the handle through the handle spacer and into t h e handle shaft.
Left Door Handle
(fixed)
-Insert the handle shaft through the door.
-Secure with a lock washer, 2 flat washers and a nut.
-Feed the handle through the handle spacer and into the handle shaft.
See Note #2
Note #1: You may need to move washers to the other side of the latch to obtain sufficient door seal.
Note #2: The final angle of the left door handle should mirror the right door handle in the closed position. Tighten the nut to secure the left handle at the desired angle.