18
AIR COOLED CHIMNEY INSTALLATION
1.Remove the knock out.
2.Cut away the insulation to gain access to the ring.
3.Remove the ring secured by four screws.
4.Slide the starter collar through the insulation wrap and affix using the four screws removed in step 3.
5.Secure the inner liner of the chimney to the fireplace 8" collar using 3 screws supplied with the starter collar (W170- 0098).
6.Follow the chimney manufacturer's instructions for in- stalling the chimney.
AIR COOLED CHIMNEY REQUIREMENTS
Use only the following brand and type of chimney.
Chimney Components | FMI 8DM |
|
|
12" Chimney Section | |
|
|
18" Chimney Section | |
|
|
24" Chimney Section | |
|
|
36" Chimney Section | |
|
|
48" Chimney Section | |
|
|
Offsets | |
|
|
Flashing | 6F8 or 12F8 |
|
|
Chimney Cap | |
|
|
Roof Support | 38 RS |
|
|
Firestop | |
|
|
Chimney Components | Wolf Steel |
|
|
Starter Collar | |
|
|
FINISHING
ATTACHING THE HANDLE AND
AIR CONTOL KNOB
The door latch is adjusted by moving the washer from one side of the latch to the other. Tighten the outer nut to secure the latch.
Install the air control threaded rod and knob.