Napoleon Fireplaces NZ6000 General Information Features, Heating Specifications, Packing List

Page 6

6

GENERAL INFORMATION

FEATURES

•Maximum log length of 32"

•Large firebox capacity - 4.8 cu ft.

•Long burn time - up to 14 hours.

•Large glass doors for maximum visibility

•Firebrick lining for firebox protection

•Optional 320 CFM blower for convection heat

•Thermostat for automatic control of the blower

•Outside air for combustion

HEATING SPECIFICATIONS

Approximate Heating Capacity up to 3,000 square feet

(Will vary with the home's floor plan, insulation and outside temperature.)

Maximum burning time up to 14 hours BTU Output per hour 10,000 to 80,000 (Cord wood method)

ELECTRICAL SPECIFICATIONS

The blower on "HIGH" draws 2.2 amps on 120 volts A.C. (approximately 250 watts).

PACKING LIST

Shipped with the fireplace:

Installation manual

Baffle

Ember strip Log retainer

Flex duct w/ start collar 10' length, 6" dia (1 for NZ150-KT or blower kit and 2 for outside combustion air supplies).

Shipped with faceplate: faceplate

12 faceplate screws

Shipped with the door(s): Installation instuctions and hardware

EPA COMPLIANCE

This heater has been certified epa exempt.

CALIFORNIA PROP 65 WARNING:

Use of this product may produce smoke which contains chemicals known to the State of Califor- nia to cause cancer, birth defects, or other repro- ductive harm.

Do not use makeshift compromises during installation. Do not block or restrict air, grille or lou- vre openings! Do not add a hood.

Burning your unit with door open or ajar creates a fire hazard that may result in a house and/or chimney fire.

All venting connections must be in compliance with the chimney manufacturers installation instructions.

Clearances referred to throughout this manual are the minimum requirements.

Your Napoleon fireplace must be installed in accord- ance with all national and local building code stand- ards and the standard of Chimney and Fireplaces, Vents and Solid Fuel Burning Appliances NFPA #211. Consult the authority having jurisdiction (such as municipal building department, fire department, fire prevention bureau, etc.) to determine the need to obtain a permit. If you are in doubt about the proper installation for your situation, contact your dealer or local building or fire official. The manufacturer does not guarantee that this fireplace and its options will completely heat your entire home.

Expansion / contraction noises during heating up and cooling down cycles are normal and to be ex- pected.

It is recommended that in all cases, the fireplace be secured to the floor. Use the pallet packing brack- ets to accomplish this.

CARE OF GLASS, AND PLATED PARTS

If the glass is not kept clean permanent discolouration and / or blemishes may result. Normally a hot fire will clean the glass. The most common reasons for dirty glass include: not using sufficient fuel to get the stove thoroughly hot, using green or wet wood, closing the draft so far that there is insuf- ficient air for complete combustion. If it is necessary to clean the glass, use a soft cloth with a non-abrasive cleaner.

Do not clean the glass when hot!

The glass is very strong but do not let burning fuel rest or fall against it and always close the door gently. Never force it shut!

If the glass should ever crack while the fire is burning, do not open the door until the fire is out and do not operate the stove again until the glass has been replaced with a new 5mm thick piece of ceramic glass, available from your Napoleon / Wolf Steel Ltd. dealer. Do not substitute materials.

For information on glass removal and replacement, see Maintenance.

Do not use abrasive cleaners to clean plated parts. Buff lightly with a clean dry cloth.

W415-0594 / A / 02.15.07

Page 5 Page 7
Image 6
Page 5 Page 7
Contents W415-0442 / C W415-0594 / a W415-0594 / a Table of Contents Napoleon Wood Fireplace Presidents Lifetime Limited Warranty Introduction General InstructionsElectrical Specifications General Information FeaturesHeating Specifications Packing ListInstallation / Framing HI-EFFICIENCY HeatingLocation and Clearances Ceiling From the base of the unit EnclosureWhen Using a Solid Pack Chimney When Using AN AIR Cooled ChimneyVertical Horizontal Rise is Run may be Between Outside Combustion AIRMantle Clearances Included with the fireplace areHearth Extension See hearth examplesHearth Examples Face PLATE, Upper GRILL, Keystone & Door Installation See Note #1See Note #2 Chimney Installation Adding Chimney Sections Straightup ElbowsOffset Chimney Installation Installing Flashing and Storm CollarConnectionto a Masonry Chimney If the ChimneyAttaching the Handle AIR Contol Knob AIR Cooled Chimney InstallationFinishing Wolf SteelOptional NZ64 Blower KIT Installation For complete instructions, see Blower kitNZ64 Blower Installation Electrical Connection Liner supplied stretches to a maximum of 10’NZ64 Blower Replacement NSK Optional Screen KITStarting a Fire Operating InstructionsOperating Sounds and Smells Draft ControlW415-0594 / a Fuel Loading and Burn Cycle Flash Fires ASH Removal ProceduresRE-LOADING the Fireplace Overnight BurnTips for Burning MaintenanceGlass & Gasket Replacement RUN-AWAY or Chimney FireSelecting Wood Creosoteformation AndremovalReplacements Fireplace and Accessory Replacement PartsAccessories W415-0594 / a Trouble Shooting Guide Symptom Problem Test SolutionRating Plate

NZ6000 specifications

The Napoleon Fireplaces NZ6000 is a premier choice for homeowners seeking an efficient, stylish, and versatile fireplace solution. This powerful unit seamlessly blends modern technology with classic design, providing exceptional warmth and ambiance in any living space.

One of the standout features of the NZ6000 is its remarkable heating capacity. With an impressive output of up to 55,000 BTUs, it can efficiently heat areas of up to 2,500 square feet, ensuring comfort during even the coldest months. The fireplace’s design allows for a dual air-wash system, promoting a clean burn while maintaining clear views of the mesmerizing flames.

The NZ6000 is built with durability in mind, featuring a robust steel construction. Its heavy-duty build ensures that heat retention and distribution are optimized, providing long-lasting performance. Additionally, the cast iron door adds a touch of elegance while enhancing the unit's efficiency. The door's large viewing area allows for an unobstructed view of the fire, creating a warm, inviting focal point in your home.

Incorporating advanced technology, the Napoleon NZ6000 is equipped with a state-of-the-art combustion system that maximizes efficiency and minimizes emissions. This includes an innovative air supply system that enables precise control over the air intake, allowing users to adjust the burn rate to suit their preferences. This not only enhances the performance of the fireplace but also ensures compliance with modern environmental standards.

Another attractive feature is the customizable design options available for the NZ6000. Consumers can choose from a variety of finishes and faceplates, allowing them to tailor the appearance to complement their home décor. The fireplace can also be paired with an array of decorative media, such as logs, stones, or crystals, giving homeowners the flexibility to create their desired aesthetic.

Safety is paramount with the NZ6000. It comes equipped with an advanced safety shut-off system, ensuring peace of mind during operation. The easy-to-use controls and user-friendly design make it accessible for everyone, from novice users to seasoned fireplace enthusiasts.

In summary, the Napoleon Fireplaces NZ6000 brings an exceptional combination of efficiency, durability, and aesthetic appeal, making it a preferred choice for anyone looking to enhance their home's warmth and ambiance. With its cutting-edge technology, customizable options, and focus on safety, the NZ6000 stands out as a top-tier investment for any modern living space.
Top Page Image Contents