20
LAMP REPLACEMENT
1.Turn off the power to the unit.
2.Turn off the gas valve.
3.Remove the door and logs.
FIGURE 42
FIGURE 41
4.Loosen the lense retainer screws and pivot the retainers out of the way.
5.Using a small flat screwdriver, gently lift the orange lense from the housing.
6.Slide the defective bulb to either side until the opposite end is disengaged. Remove the bulb lifting the disengaged end.
7.Replace with a 75 watt halogen lamp
Install the replacement bulb using the protective wrap to avoid touching the lense, then disgard the protec-
tive wrap.
8. Repeat steps 5 - 1 for installation.
BLOWER REPLACEMENT
The Napoleon MADISON comes equipped with a heat circu- lating blower. The blower is
Drywall dust will penetrate into the blower bearings, causing irreparable damage. Care must be taken to pre- vent drywall dust from coming into contact with the blower or its compartment. Any damage resulting from this condition is not covered by the warranty policy.
1.Turn off the power to the fireplace.
2. Turn off the gas valve. | FIGURE 43 |
FIGURE 44
4.To remove the lamp assembly, remove the two log locat- ing studs located just behind the main burner. It is not neces- sary to disconnect the wires, the assembly can lay along the right side of the firebox.
FIGURE 45
3.Remove the glass door, logs, rear log support, side brick panels, rear baffle, and rear panel.
5. The blower mounting plate can now be removed. Remove the six screws that secure the plate to the firebox back. The blower is secured to this plate.
6. Disconnect the wire connectors and ground before attempt- ing to remove the blower from the plate.
7. When